Deleting Raid Volumes; Supported Sas Raid Configurations; Configuring The System Bios To Enable Sas Raid Functionality - Lenovo ThinkStation D10 6427 User Manual

Deleting RAID volumes

This section describes how to use the Intel Matrix Storage Manager option ROM
Configuration Utility to delete RAID volumes.
1. Press Ctrl+I when prompted to enter the Intel Matrix Storage Manager option
2. Use the arrow keys to select the RAID volume to be deleted, and press Delete.
3. When prompted, press Y to confirm the deletion of the selected RAID volume.
4. After deleting a RAID volume, you can:

SUPPORTED SAS RAID configurations

This section provides information that is applicable only for a Windows
environment. For information about configuring RAID in a Linux environment,
contact your Linux software provider.
The following RAID configurations are supported on the Lenovo ThinkStation:
v RAID Level 0 – Striped disk array
v RAID Level 1 – Mirrored disk array
v RAID Level 1E (1 Enhanced)
Configuring the system BIOS to enable SAS RAID
functionality
This section describes how to configure the system BIOS to enable SAS RAID
functionality.
1. Press F1 to enter the system BIOS setup.
2. Use the arrow keys on the keyboard to select Advanced, and press Enter.
3. Use the arrow keys to select the LSI SAS Interface, and press Enter.
24
User Guide
ROM Configuration Utility.
v Return to step 1 to delete additional RAID volumes.
v See "Creating RAID volumes" on page 23 for RAID volume creation.
v Use the arrow keys to select Exit and press Enter.
v Use the arrow keys to select Reset Disks to Non-RAID, and press Enter.
a. Use the arrow keys and space to mark individual physical disks to be
reset.
b. Use the space key to select, and then press Enter to complete the
selection.
c. When prompted, press Y to confirm the reset action.
d. After completing the Reset Disks to Non-RAID function, you can:
– Return to step 1 to delete additional RAID volumes.
– See "Creating RAID volumes" on page 23 for RAID volume creation.
– Use the arrow keys to select Exit and press Enter.
– Two drives minimum.
– Better performance and no fault tolerance.
– Two drives.
– Improved read performance and 100% redundancy.
– Three drives minimum
- Can always recover from a single drive failure and, in some cases, can
recover from two drives.
- High Performance.