3. Locate the connector for the mouse. See "Locating connectors on the front of
4. Disconnect the failing mouse cable from the computer.
5. Connect the new mouse cable to the connector.
6. Go to "Completing the installation."
Completing the installation
After replacing the parts, you need to close the computer cover and reconnect
cables, including telephone lines and power cords. Also, depending on the part
that was replaced, you might need to confirm the updated information in the
Setup Utility program. See "Starting the Setup Utility" in the User Guide.
To complete the part installation:
1. Ensure that all components have been reassembled correctly and that no tools
2. Make sure that the cables are routed correctly before replacing the computer
26
Hardware Replacement Guide
the computer" on page 2 and "Locating connectors on the rear of the
computer" on page 3.
Note: Your mouse might be connected to the standard mouse connector 1 at
the rear of the computer or to a USB connector 2 at either the front or rear of
the computer.
or loose screws are left inside your computer. See "Locating components" on
page 1 for the location of the various components.
cover.