Advertisement
Quick Links
Advertisement
Summary of Contents for Keison Anton Flowclean Plus
- Page 1 USER MANUAL PLEASE READ THROUGH ALL INSTRUCTIONS BEFORE USE...
-
Page 2: Table Of Contents
CONTENTS Page 2 - Unpacking Page 3 - Heating system preparation and tips Page 4 - Connections and controls Page 6 - Connecting to heating system Page 7 - Power flushing procedure Page 9 - Technical data and safety Page 10 - Spares and accessories... -
Page 3: Unpacking
UNPACKING Thank you for purchasing the Flowclean Plus power flushing and descaling pump, designed to flush central heating systems and remove sludge, corrosion and scale build-up, curing circulation problems and unwanted boiler noise, leaving a more efficient and protected heating system. Please carefully remove your Flowclean Plus from the packaging and check the contents as follows: •... -
Page 4: Heating System Preparation And Tips
HEATING SYSTEM PREPARATION AND TIPS Always run heating system prior to power flushing to establish the problem areas such as cold spots on radiators or slow circulation, you can then make sure the strongest concentration of chemicals are directed to these problem areas. Before power flushing the system it is important to check the following: All radiator valves are fully open, both sides of radiator. -
Page 5: Connections And Controls
CONNECTIONS AND CONTROLS Dump hose connection Right hand valve (Return) Left hand valve (Flow) Return hose connection Overflow hose connection Flow hose connection Cold water inlet tap Return hose connection 3 position valves Please note correct position Dump - Upward of drain tap on magnetic filter, Closed - Horizontal fitted using swivel coupling... - Page 6 CONNECTIONS AND CONTROLS Power On-Off switch The flow diverter valve points in the direction of flow Chemical fill point (funnel provided) Min & Max level indicators Page 5...
-
Page 7: Connecting To Heating System
CONNECTING TO HEATING SYSTEM Cap off cold feed and expansion pipe or create temporary loop on vented systems. Feed and expansion tank Mains cold feed Connect at pump valve connections, this method is Cylinder most commonly used. Zone Valve Circulating Pump Connect at radiator valve connections, this method is most commonly used where a combination or system boiler... -
Page 8: Power Flushing Procedure
POWER FLUSHING PROCEDURE Please note: Supameg Magnetic in-line filter maintenance During the cleaning process you will need to keep your eye on the in-line magnetic filter as this will attract iron oxide particles during the procedure and gradually become choked. To empty simply turn off power switch to unit, set right hand valve (return) to closed position (make sure flow direction of water is returning down the return hose) remove the magnet from top of the filter, open the small drain tap over bucket with small length of hose attached, turn on power switch and drain debris into bucket. - Page 9 POWER FLUSHING PROCEDURE Step 8) Individual radiator cleaning For best results all radiators should now be cleaned individually. Turn off all radiator valves on system apart from furthest radiator, continue to recirculate through individual radiator for 5-10 minutes, regularly reversing the flow. (obviously always making sure at least one radiator is fully open at any one time).
-
Page 10: Technical Data And Safety
TECHNICAL DATA AND SAFETY Dimensions: W43 x D48 x H56 (cm) Weight: 18 KG with transport trolley Tank capacity: 37 litres Compatible with all approved chemicals Working fluid temperature up to 70ºC Efficient cleaning up to 20 radiators Flow rate: 5,400 ltrs/hr max 0.45 HP motor with IP54 protection Max working head: 2bar In order to maintain continued flushing pump efficiency and reliability it is of... -
Page 11: Spares And Accessories
SPARES AND ACCESSORIES Order code: Description: AFEH kit 3mtr hose extension kit with straight connector and end caps AFHEA Plate heat exchanger adaptor AFPHA Circulating pump head adaptor AIRG Laser infra-red digital thermometer with belt pouch ASMC Supameg compact filter with valves for heating system use ASMC/F Supameg compact filter with connection coupling for power flusher use AA15/HDH... - Page 12 Thank you for reading this data sheet. For pricing or for further information, please contact us at our UK Office, using the details below. UK Office Keison Products, P.O. Box 2124, Chelmsford, Essex, CM1 3UP, England. Tel: +44 (0)330 088 0560 Fax: +44 (0)1245 808399 Email: sales@keison.co.uk...