LED Lights Canada SP108E Quick Start Manual

SP108E Digital Wi-Fi Controller
App: LED Shop
Contents
SP108E digital Wi-Fi controller
Small flat head screwdriver
NOTE: This controller will only work on a 2.4G network. It will not connect to a 5G network.
Wiring
To get started, unravel the LED strip from the roll. Connect the wires to the terminals in the controller
and tighten the screws to secure the connection. ​ ( Figure 1.)
Please be aware of the arrows on the flex strip. The direction indicates the flow of current. Make
sure that you are connecting from the back end of the arrow. Reversing this will cause the strip
not to illuminate.
2.2. You can now connect the driver to the controller as shown in ​ F igure 2.​ :
2.3. To confirm that all of your connections are successful, supplying 110V AC power to the driver should
result in the flex strip lighting up. If your lights are illuminated, please proceed.
[3] App Download and Setup
3.1. Download ​ L ED Shop
There are two ways to connect the controller to the network:
[A] AP mode ​ w ill allow you to connect your device directly to the controller.
1. Within 20 seconds of powering the controller, go to your device's WiFi settings. Find and connect
to ​ S P108E ​ a s you would with any network.
2. Launch the app. The app will instantly display and connect to the SP108E controller. Proceed to
Step 3.2​ .
LED Lights Canada
4404 97 St NW
Edmonton, AB T6E 5R9
​
f rom your device's app store (Google Play or App Store).
1
SKU: CTR750
The SP108E can control up to 2048 pixels.
This can be done by running the
in series from the end of the first strip to the
beginning of the last flex strip.
Figure 1.
Black​ wire to ​ G ND
Green​ wire to ​ D AT
Red​ wire to ​ V CC
Blue wire does not get connected
Figure 2.
Plug in the barrel connector OR wires
from the driver to the controller.
Negative​ to ​ G ND
Positive ​ t o ​ V CC
Toll Free​ : 1-800-677-2698
​ L
ocal​ : 780-800-0059
​ E mail: ​
i nfo@ledlightscanada.com
DAT wire