Page 1
KA162 4 PORT HDMI KVM SWITCH 4K (AUTO SWITCHING) Features Computer: HDMI input maximum support 4K2K30Hz RGB4:4:4, 8 Bit Display: HDMI input maximum support 4K2K30Hz YUV 4:4:4, 8 Bit The Four USB-TYPE B interface pass through three USB interface to the corresponding host of HDMI signal channel.
Panel Descriptions 1) Bi-coloured light Green Status = USB connected Red Status = HDMI connected Orange Status = USB + HDMI connected 2) Select button (Reset & Switch). 3) Reset status indication. 1) 12V DC power input. 2) Upgrading the firmware 3) HDMI out port.
Connecting and Operating 1. Connect all the PC to the HDMI KVM switch, then start all the PC. 2. After all the PC are started in step 1, then you can switch to any PC by keyboard hot key or the key pad on the KVM panel. (For example, if you want to control the PC connected to HDMI IN 2 just press the key under the PORT 2 LED indicator, or the keyboard hot key commands described following).
Page 7
HOW TO USE KEYBOARD HOT KEYS: To enter Hotkey mode, press Scroll lock twice quickly, the buzzer beeps once. Input any Hotkey combination that follows; the buzzer beeps once when input is completed.
Page 8
NOTE: If you need to do auto switching within a specified time Step 1 : Step 2 : Problems Solutions Try below ways: 1. Unplug and plug the USB keyboard and mouse 2. Make sure the USB cable connections from KVM switch to host devices are all Keyboard and mouse don’t work at correct all no matter which input port is...