earSHOTS Wireless Earphones Instructions

Table of Contents

Download this manual

UNBOXING The kit list is:

earSHOTS self-charging case

Left & right earshot

Micro-USB charging cord

Self-charging case

Take earSHOTS out of self-charging case

2. SIMULTANOUSLY press and hold the button on the back of BOTH earSHOTS for 3s.

When the lights turn on you can release the buttons

3. Wait for one of the earSHOTS to flash red/blue (this can take up to 30sec)

4. Open Settings on your device and select Bluetooth

5. Wait for earSHOTS to appear in list of devices

6. Select earSHOTS

Note: See Trouble shooting section if two earSHOTS appear in the list of devices.

SIMULTANEOUSLY press and hold the button on the back of BOTH earSHOTS for 3s.

When the lights turn on you can release buttons

Note: When the L earSHOT is flashing red/blue it means earSHOTS are ready to connect to

a device.

SIMULTANEOUSLY press and hold the button on the back of BOTH earSHOTS for 5s

2. earSHOTS lights will pulse red, then turn off

Tip: Placing earSHOTS in the self-charging case will also turn them off

Hold the earSHOTS by the arm, close to the earbud

2. Seperate the earbud from the hook

3. Tuck the earbud into the ear over the ear canal

4. Lift the hook over the top of your ear and slide down behind

5. Line up the end of the earbud with the protruding line on the hook part of the

earSHOT

Note: Tuck the hook tight in behind your ear, where it meets the side of your head

First tuck the red earbud in over the ear canal

2. The push the earbud into the ear

Let's play... earSHOTS Instructions & Fit Guide

Table of Contents

Need help?

Do you have a question about the Wireless Earphones and is the answer not in the manual?

Page 1 2. SIMULTANOUSLY press and hold the button on the back of BOTH earSHOTS for 3s. When the lights turn on you can release the buttons 3. Wait for one of the earSHOTS to flash red/blue (this can take up to 30sec) 4. Open Settings on your device and select Bluetooth 5.
Page 2 Solo/Dual mode Activating solo mode Start with earSHOTS turned off 2. In Settings on your device, disconnect or forget the earSHOTS connections that are currently stored 3. Select which earSHOT you want to use in Solo mode 4. Turn on the selected earSHOT by pressing and holding the button on the back for 5.
Page 3 Clear the earSHOTS from your devices list by selecting "Forget Device" or 'Disconnect" on all the connections 2. On BOTH earSHOTS, simultanously press and hold the buttons on the back for 10s 3. At the end of the 10s do 3 short presses of both buttons simultanously...