Progress HangTime Wall Mount Quick Start Manual

1. The product includes 1 HangTime
bracket and threaded mount housing.
2. Screw fasteners and screw anchors for mounting to the wall.
3. Screw fasteners for assembling the upper mount housing to the wall bracket.
4. Screw fasteners for mounting your skateboard deck to the HangTime
5. Instructions.
HangTime
IMPORTANT: Determine the location for the HangTime
mount and your skateboard. Do not hang on a ceiling or angled walls unless there is sufficient support to hold the board and mount.
Location must be free from obstructions, away from beds, doors and traffic areas. It is recommended that your HangTime
be mounted using the screws and anchors provided. HangTime
requires a Phillips screwdriver and a 3/16" drill. Use of a cordless screwdriver or drill with a Phillips bit will make installation easier.
PLEASE CONTACT US AT 860-436-4470 IF YOU REQUIRE ADDITIONAL HELP
Drill
Other HangTimeUSA
HangTime
for snowboards
HangTime TM
HangTime
for Skateboard Decks
(Threaded Mount)
HangTime Wall Mount Package Contents
TM
TM
Mount Assembly for mounting a single skateboard deck; wall
TM Wall Mount for Skateboard Decks Instructions
DURING INSTALLATION.
Tools Required (not included)
TM
Wall Mount
TM
Made in the USA by Progress, Inc.
and HangTimeUSA TM
www.HangTimeUSA.com
Copyright 2012. Progress, Inc. All rights reserved.
Wall
TM
Mount
Wall Mount. Wall must be sound, strong enough to support the HangTime
TM
is not responsible for improper or inadequate mounting. Assembly
TM
Phillips Screwdriver
Products:
are trademarks of Progress, Inc. Newington, CT
sales@HangTimeUSA.com
TM
Wall Mount.
3/16" Drill Bit
Magnetic Skateboard Wall Mount
for temporary skateboard mounting
TM
mount
TM