Page 1: Table Of Contents
You will need ..........Prior to Assembly and Use Tips Regarding CTT Locator’s Battery Assembly Instructions...
Page 2: The Ctt Locator
Prior to Assembly and Use Connect a Micro USB cable to the USB port on the CTT Locator. The USB port is located at the side of the device next to the power switch. This will start the charging process and top off the battery. The battery is fully charged when the red indicator light goes out and the blue light comes on.
Page 3: Assembly Instructions
For safety during transport, the battery is at a half charged state. While you can use the CTT Locator without fully charging the battery, you will not experience the full battery life until the unit is fully charged. Assembly Instructions Unpack the hand held yagi antenna from the packaging.
Page 4: Locator Buttons And Indications
3. Enter this full url into the browser. Note that the https:// is important: https://locator.click/ In a few moments, a webpage will load and show the main locator screen. Parts of the CTT Locator Indicator Light Meaning Power and Low Battery Indicator...
Page 5 Figure 3: Locator Diagram Port or Switch Usage Power Switch Toggle switch to the left to turn the unit on. Wait a few seconds before usage. USB Charging Port Connect micro-USB cord to any computer USB port or USB wall wart to charge.
Page 6: Screen Overview
Screen Overview When you load the Locator screen, an interface will appear. You can change the various modes of the locator by clicking on the icons at the bottom. First, we will go over the title bar: The circle on the right will flash red when a tag is detected. A rotating circle animation indicates that the locator is actively connected to the phone.
Page 7 Figure 4: Home View Figure 5: Locator Main View...
Page 8: Tag View
Tag View The tag view provides a signal strength indicator to help you localize a tag. As the tag signal gets stronger, more bars appear. the negative number under the signal bars is the signal strength in dBm, or decibel milliwatts.
Page 9 Figure 7: Identify View Figure 8: Favorite View...
Page 10: Download View
Figure 9: Search View Download View The Download view is where you can download both ES200 and Tag Data. Clicking on these will initiate a download to your device. Figure 10: Download View Settings View The Sound options allow you to enable or disable the ping sound. Signal based volume will slightly adjust sound levels to indicate signal strength (not all phones support this feature).
Page 11 WiFi Access Point mode, switching to off, will disable the hotspot functionality and allow it to connect to a local network. This is not required for software updates. The locator will then respond to https://locator.local/ Figure 11: Settings View Storage indicates space left on the locator. Note that the operating system and locator software do take a majority of the space on the device, which is normal.
Page 12: Importance Of Shutdown
Software update updates the locator to a new version of software. Note it is not advised to do this unless instructed by Cellular Tracking Technologies. Diagnostics will provide technical hardware information that is sometimes useful for technical support.
Page 13 • On your first reading with a steady signal, rotate slowly to identify the initial bearing of the tag. You may want to make two full rotations to verify direction. Once you master this technique, you can scan side-to-side for faster localization. •...
Page 14 • Removed log file start header Version 3.0.1 New Features • Locator power light now appears immediately when Locator is switched on • Power switch off feature for safer handling of SD card Fixes/Improvements • Software version correction (properly displays 3.0.1) •...
Page 15 • Tag ID signal threshold fixed to -39 dBm or stronger • Rose graph removed • ES200 data stored in raw form (no local decoding) • I2C scan doesn’t fit on some smaller displays • LED testing function not included •...
Page 16 You can submit your suggestions and any errors to our Customer Service Desk here and we will work to incorporate them in future revisions. All material © Cellular Tracking Technologies, 2021.