Advertisement
Operate the fixture only when you are familiar with the features on the fixture. Do not permit operation
by persons not qualified.
All modifications to the fixture. There are absolutely no exceptions.
If the fixture is operated in any way different to the one described in this manual, this light maybe
damaged and the guarantee will be void.
4. Installation
A safety chain or cable should also be used as a secondary point of holding the fixture in case the
clamp comes loose. Never hang the fixture without a safety chain or cable.
If you are not qualified or have any doubts about hanging the fixture then do NOT hang it.
5. DMX-512 Control Connection
Connect an XLR cable to the female 3-pin XLR output of your DMX controller. The other end should
be connected to the male 3-pin XLR input of the fixture. Then daisy-chain out of the first fixture into
the next fixture or other DMX device. Never "Y" split the DMX connection.
If you need more cable, then it should be two core, screened cable fitted with a 3 pin XLR input and
output connector. Please refer to the diagram below.
DMX-512 connection with DMX terminator
For installations where the DMX cable has to run a long distance or is in an electrically "noisy"
environment, it is recommended that a DMX terminator is used. This helps prevent corruption of the
digital control signal. The DMX terminator is simply a 3 pin XLR plug (male) with a 120 Ω resistor
connected between pins 2 and 3. It is then plugged into the output XLR socket of the last fixture or
other dmx device in the chain. Please see illustration below.
2
3
1
Advertisement
