Page 1
® Algae Control System (ACS) ™ Owner’s Manual 120-volt ac Model: 210-240-volt ac Model: 24-volt ac Model: 24-volt dc Model: RBacs400 RBacs400-eU RBacs400-UK RBacs400-24-ac RBacs400-24-dc RBacs500 RBacs500-eU RBacs500-UK RBacs500-24-ac RBacs500-24-dc RBacs600 RBacs600-eU RBacs600-UK RBacs600-24-ac RBacs600-24-dc Important safety InstructIons Read, UndeRstand, follow and save these instRUctions...
. Please read and follow all of the instructions in this manual . If you have any questions concerning your Rain Bird device, call us at 520-741-6100. Thank you. Important Safety Information...
(A) is in the water as this will result in the deforming of the transducer head and will void your warranty . *If using 24-volt DC power model with batteries see separate instruction booklet . Rain Bird® Algae Control System™ (ACS) • Owner’s Manual SAVE THESE INSTRUCTIONS...
2 ft 2 ft obstructions on your plans . water level has dropped but there is still 2’ of water under unit. Rain Bird® Algae Control System™ (ACS) • Owner’s Manual SAVE THESE INSTRUCTIONS...
Installation There are several different ways to install your Rain Bird unit in the water depending on conditions . In an ® unlined pond you can use the Stakes or Poles Method . You can also mount the unit to a dock or floating raft .
* It is EXTREMELY important you do not connect to power source before you put it in the water as this can result in damage to the transducer head and will void your warranty. Rain Bird® Algae Control System™ (ACS) • Owner’s Manual SAVE THESE INSTRUCTIONS...
Adjust the anchoring rope to make sure there is no slack in the line to prevent the unit from sliding down the pond’s slope . Now that the unit is in the water* you may plug the Rain Bird power supply into the GFCI outlet .
Rain Bird Algae Control System to bring the algae under control and clear the water . easy-to-read Indicator lights The Rain Bird ACS device has two lights on the power supply box . The solid “ON” green light indicates that the Power Supply is receiving electricity . The blinking green light indicates that your transducer is connected properly to the Power Suppy and receiving power to produce the ultrasonic waves .
. Failure to keep the face clean will interfere with the ultrasonic waves and result in reduced effectiveness of the device . Unplug the Rain Bird power supply* from the Class A GFCI electrical outlet .
Troubleshooting Check the following guide for possible cause of a problem before contacting Rain Bird for service assistance . ® Symptom Causes Solution Both indicator lights are off Electric power failure Test and turn on power to grounded (earthed) power supply . (For power models install only to a Class A GFCI receptacle or equivalent .
Golf Products Golf Rotors: DR, DH, DS, ESR, EAGLE™ Series and EAGLE IC™ Series, Rain Bird Series and Rain Bird IC™ Golf rotors - 3 years . Additionally, any DR, DH, DS, EAGLE™ Series and EAGLE IC™ Series, Rain Bird Series and Rain Bird IC™ Golf Rotor sold and installed in conjunction with a Rain Bird Swing Joint - 5 years .
Page 13
***THIS PAge INTeNTIONAlly lefT BlANK***...
Page 14
E322023 Certified to NSF/ANSI 61 & 372 power supply for Rain Bird power supply for outdoor use. outdoor use. ePa est. 074929-Ma-001 Rain Bird Corporation Rain Bird Corporation Rain Bird International, Inc.
Need help?
Do you have a question about the RBACS400 and is the answer not in the manual?
Questions and answers