Current Dual-Lite CRU Series Quick Start Manual

CHICAGO APPROVED RECESSED EMERGENCY UNIT
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
WARNING: RISK OF ELECTRIC SHOCK - NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIP-
MENT IS ENERGIZED.
WARNING: RISK OF ELECTRIC SHOCK - NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS
IS ENERGIZED.
INJURY OR SIGNIFICANT PROPERTY DAMAGE - For your protection, read and follow these warnings and instructions
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS
carefully before installing or maintaining this equipment. These instructions do not attempt to cover all installation and mainte-
INJURY OR SIGNIFICANT PROPERTY DAMAGE - For your protection, read and follow these warnings and instructions
nance situations.
carefully before installing or maintaining this equipment. These instructions do not attempt to cover all installation and
maintenance situations.
WARNING: RISK OF FIRE - Lamps are hot. Keep combustible material away from hot parts. Observe lamp manufacture's
WARNING: RISK OF FIRE - Lamps are hot. Keep combustible material away from hot parts. Observe lamp manufacture's warnings, recommendations and restrictions on lamp operation and maintenance. Make sure lamps are correctly installed.
warnings, recommendations and restrictions on lamp operation and maintenance. Make sure lamps are correctly installed.
• All service shall be performed by qualified service personnel. This product must be installed and maintained in accordance
• All service shall be performed by qualified service personnel. This product must be installed and maintained in
with the applicable installation codes by a person familiar with the construction operation of the product and the hazards
accordance with the applicable installation codes by a person familiar with the construction operation of the product and the
involved.
hazards involved.
• This product must be installed in accordance with the applicable installation codes and ordinances.
• This product must be installed in accordance with the applicable installation codes and ordinances.
• Before wiring to power supply, turn off electricity at fuse or circuit breaker.
• Before wiring to power supply, turn off electricity at fuse or circuit breaker. • Disconnect A.C. power and unplug battery before servicing.
• Consult your local building code for approved wiring and installation.
• Disconnect A.C. power and unplug battery before servicing.
• May be used outdoors under cover. (20°C-50°C)
• Consult your local building code for approved wiring and installation.
• Do not let power supply cord touch hot surfaces.
• May be used outdoors under cover. (20°C-50°C)
• Do not mount near gas or electric heater.
• Do not let power supply cord touch hot surfaces.
• Equipment should be mounted in Iocations and at heights where it will not readily be subjected to tampering by unauthorized
• Do not mount near gas or electric heater.
personnel.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by • The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Do not use this equipment for other than intended use.
unauthorized personnel.
• The AC voltage rating of this equipment is specified on the product label. Do not connect equipment to any other voltage.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Do not use this equipment for other than intended use.
• The AC voltage rating of this equipment is specified on the product label. Do not connect equipment to any other voltage.
IMPORTANT SAFEGUARDS
including the following:
INSTALLATION
CRU Series
Chicago Approved Recessed Emergency Unit
Installation, Operation and Maintenance
for 27 Watt or 50 Watt Series