Advertisement
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The
tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
......................................................................................................................................................
Customer Service Email: CustomerExperience@belnick.com | Phone: 866-552-2810
HANGING HAMMOCK
SDA-AD608001-NAT-GG / SDA-AD608001-GY-GG
Thank you for your purchase!
CHAIR WITH STAND
Advertisement
Table of Contents
Summary of Contents for Flash Furniture SDA-AD608001-NAT-GG
- Page 1 To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed. …………………………………………………………………………………………………………………………………… Customer Service Email: CustomerExperience@belnick.com | Phone: 866-552-2810 SDA-AD608001-NAT-GG / SDA-AD608001-GY-GG...
- Page 2 Have a Question/Concern? Quality products and first-class customer service are the cornerstone of long-lasting consumer relationships. We strive toward excellence in all we do and want you to be completely satisfied with your purchase. Please contact our exceptional Customer Experience Agents at the email address or phone number shown below to assist you with any product questions or issues before requesting a return.
- Page 3 Parts Part Drawing Description Support connector Chair Support legs Support pole Screw M8*57 Screw M6*15 Wrench Allen Wrench Clevis Pin Spring Chain Anchor Shackle ……………………………………………………………………………………………………………………...
- Page 4 Step 1 Attach Support Legs (Part C) to Support Connector (Part A) using (4) M6*15 Screws (Part F). Tighten using Allen Wrench (Part I). Bring to the upright position. Support Legs NOTE: Ensure Feet are facing down. Support Connector Step 2 Attach Support Pole (Part D) to Support pole Support Connector (Part A)
Need help?
Do you have a question about the SDA-AD608001-NAT-GG and is the answer not in the manual?
Questions and answers