TEH LT606 Manual
  1. Manuals
  2. Brands
  3. TEH Manuals
  4. Trimmer
  5. LT606
  6. Manual

TEH LT606 Manual

Cordless trimmer
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Cordless Trimmer
LT606
Tools for Every Home

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LT606 and is the answer not in the manual?

Questions and answers

Summary of Contents for TEH LT606

  • Page 1 Cordless Trimmer LT606 Tools for Every Home...
  • Page 2 LT606 Model Rated Voltage DC 20V Battery Motor Brush No Load Speed 28000r/min Collet Chuck Capacity 6-8mm Battery Release Button Compatible Battery LB4.0Ah On/Off Switch Depth Gauge Quick Locking Clip Lock Nut...

  • Page 3: Electrical Safety

    e) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. f) If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply.

  • Page 4: Use And Handling Of The Cordless Electrical Power Tool

    SPECIAL SAFETY DIRECTIONS FOR BATTERY-OPERATED TOOLS l) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. a) Ensure that the device is switched off before inserting the battery. Inserting a battery into a n) Use the power tool, accessories and tool bits etc.

  • Page 5: Residual Risks

    e) Connect the charger only to a socket with an earth. Ensure that the mains voltage matches the a) Cuts specifications on the charger rating plate. Risk of electric shock. b) Ear damage if working without ear protection. f) Disconnect the charger from the mains before closing or opening connection to the battery / c) Damage to your health caused by swinging your hands and arms when operating the appliance power tool / device.

  • Page 6: Installation Instruction

    INSTALLING OR REMOVING TRIMMER BIT 8. Keep hands away from rotating parts. 9. Make sure the trimmer bit is not contacting the workpiece before the switch is turned on. NOTE 10. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit.
  • Page 7 OPERATION INSTRUCTION INSTALLING OR REMOVING THE PARALLEL RULER ON THE PLUNGE BASE Optional accessory SWITCH ACTION Insert the guide bars into the holes in the plunge base, and then tighten the wing bolts. To remove the ruler, follow the installation To turn on the tool, press the switch button and push the button forward.
  • Page 8 NOTE 4. Move the tool with the straight guide flush with theside of Before cutting on the actual workpiece, it is recommended to make a sample cut. The the workpiece. proper feed speed depends on the trimmer bit size, the kind of workpiece, and depth of cut. Moving the tool forward too fast may cause a poor quality of cut, or damage to the bit or motor.
  • Page 9 USING THE TOOL WITH THE PLUNGE BASE Using the straight guide Optional accessory Always hold the grips firmly with both hands during operation. Operate the tool in the same way as 1. Loosen the screws on the base and remove them the trimmer base.

  • Page 10: Maintenance

    To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by TEH Authorized or Factory Service Centers, always using TEH ladies/gentlemen： employer：...

Table of Contents