Excelsior MIDIVOX III Series Software Upgrade

Excelsior MIDIVOX III Series Software Upgrade

Mvox3 13 software release

Advertisement

Quick Links

EXCELSIOR ACCORDIONS
SOFTWARE UPGRADE FOR MIDIVOX "Serie III" ACCORDIONS & EVK-1
===========================================================
MVOX3_13
May 1996

PREVIEW

The
new
MVOX3_13
III" accordions
very interesting and useful functions to your instrument:
1) Midi
"Bank
Control
Change
transmitted,
thus
standard 128 (up to
selected).
2) A
enabled
separately on each section.
3) A
"Program
inhibit
Program Change message transmission from User
Memories, on each
effective use of
4) The
factory-preset "key velocity" parameter, which is sent
at
any time a key or button is pressed,
programmable,
values can be stored
5) A
new
footswitch function has been added
Temporary
Section
TRBL1
and
TRBL2 sections.
6) Two
selectable volume response curves (LOgarithmic or
Linear)
are now available to program the action of the swell
pedal when
used as volume control (Control Change #7) .
software
release
upgrades
your
Select Messages" (Control Change
#32)
can
now
allowing to select sounds beyond the
16384
banks of 128 sounds each can be
function
(+/- 12
Change Filter" function is
section
separately, thus allowing a more
the
User Memories.
in each section separately, and programmed
in the User Memories.
Switching)
for
MIDIVOX
accordion
or
be
programmed
half-tones)
available
is now user-
to allow fast switching of the
1
"Serie
EVK-1's, adding
#0
and
and
can
be
to
("St"
-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MIDIVOX III Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Excelsior MIDIVOX III Series

  • Page 1 EXCELSIOR ACCORDIONS SOFTWARE UPGRADE FOR MIDIVOX "Serie III" ACCORDIONS & EVK-1 =========================================================== MVOX3_13 May 1996 PREVIEW MVOX3_13 software release MIDIVOX "Serie III" accordions upgrades your accordion EVK-1's, adding very interesting and useful functions to your instrument: 1) Midi "Bank Select Messages" (Control Change...
  • Page 2 OPERATING INSTRUCTIONS variations have been introduced to original exhisting features functions - except for what explained in note below thus the following instructions can be regarded an integration to the MIDIVOX III, Jan. 95, Owner's Guide. NOTE: Functions "LOADc" and "SAVEc", explained in Appendix of the Owner's Guide, are not available any more within the new release MVOX3_13 .
  • Page 3 bank, pressing TRBL1, TRBL2, ecc. c) Press UP or DWN to set the desired bank number (get the right number from the expander's user guide), keeping in mind that numbers shown MIDIVOX display hexadecimal notation - same way as reported in the most of expander user guides -, thus 09 is followed by 0A, 0B, 0C,...
  • Page 4 Select the sections where you want the transposer action to effective, switching on any of the section buttons (TRBL1, TRBL2, etc.). The transposer settings can be stored into the User Memories. PROGRAM CHANGE FILTER Program Change Filter is used to deactivate "Program Change"...
  • Page 5 The Key Velocity value shown on display ranges from "00" to "99". This is a relative value: "00" corresponds to an absolute value of 28, "99" corresponds to 127, which is the maximum allowed by Midi Standards. The factory preset absolute value is 64 (the display reads "36"). All set values can be stored into the User Memories FOOTSWITCH FUNCTION "St"...
  • Page 6 LInear curve has been set. To change the curve setting, press the UP or DWN buttons. ----0---- For further information or enquiries please contact: CEMEX Compagnia Elettro Musicale Excelsior s.r.l. Via Sardegna, 1 60022 Castelfidardo (AN) Italy ph. +71-7820982...

This manual is also suitable for:

Evk-1

Table of Contents