Advertisement
Owner's MANUAL
9L Manual Fluid Extraction Pump
WARNING
Please read all instructions and warnings carefully before use
• This unit is not intended for use with gasoline.
• For safety reasons, do not use the unit to extract or store dangerous chemicals, poison, acid, alkaloid, or solvents.
• Do not use the unit to extract, siphon or store petroleum or other highly flammable liquids.
• Do not throw, drop or mishandle the unit.
• Do not disassemble, tamper with or modify the unit for any other purpose than that for which it was originally intended.
• Do not store either the unit or suction tubes near areas of high temperatures, direct sunlight, rain or snow.
• It is highly recommended that the unit be drained and cleaned after each use.
®Registered trademark of JET Equipment & Tools Ltd.
1
www.jetgroupbrands.com
Prod. No. 350551
Mod. No. JMEP-9
M15-HT350551
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Jet JMEP-9
Summary of Contents for Jet JMEP-9
- Page 1 • Do not store either the unit or suction tubes near areas of high temperatures, direct sunlight, rain or snow. • It is highly recommended that the unit be drained and cleaned after each use. ®Registered trademark of JET Equipment & Tools Ltd. M15-HT350551...
- Page 2 EXTRACTOR PARTS Extractor Unit Tube Storage Unit Instruction Manual Main Suction Tube Brake Tube with Rubber Fitting Extracting Tube www.jetgroupbrands.com...
- Page 3 EXTRACTOR UNIT COMPONENTS Housing Cover Pressure Release Valve Reservoir Tank Tube Storage Unit Footboard Base Hand Pump Handle Fluid Outlet Housing Fluid Inlet Coupler Fluid Inlet Tube Extracting Tube Brake Tube with Rubber Fitting www.jetgroupbrands.com...
- Page 4 OPERATING INSTRUCTIONS Notes: When using the Manual Fluid Extraction Pump to extract engine oil, first you need to make sure the vehicle is level, and then run the engine for about 5 minutes to warm the oil and allow any sludge or contamination within the oil to mix.
- Page 5 Insert the Extracting Tube ( L ) into the dipstick hole until it reaches the bottom of the oil pan. Connect the Fluid Inlet Tube ( K ) into the Fluid Inlet Coupler ( J ) with the Fluid Inlet Tube Adapter.
- Page 6 Disconnect the Fluid Inlet Tube ( K ) and the Extracting Tube ( L ), remove them from the dipstick hole, open the Fluid Inlet Coupler ( J ) and dispose of the oil or fluid in accordance to the laws and guidelines of your province. www.jetgroupbrands.com...
- Page 7 PARTS LIST www.jetgroupbrands.com...
- Page 8 PART LIST Index Parts No. Description Unit Index Parts No. Description Unit PX90M-01 Cover Housing PX90-12 Fixed Strip PX90-49 Release Button PX90-35 Screw ø 4 x 10mm PX90-49-1 Spring PX90-36 Screw M8 x 16mm PX90-06 Fluid Inlet Coupler PX90M-29 Ring Seal PX90-14 O Ring 25.2 x ø2.7mm PX90-18...
Need help?
Do you have a question about the JMEP-9 and is the answer not in the manual?
Questions and answers