GE Profile XPIOX3BCBT Owner's Manual page 9

Care and Cleaning
Removal of Mineral Deposits
Opal Cleaning Kit and follow instructions inside.
3. Clean the sensors with vinegar and wipe clean with water. After draining the vinegar, run three rinse cycles,
Cleaning the Bin and Tray
The drip tray should be wiped dry. Water left in this area may leave deposits. To clean the drip tray, remove the tray from Opal
chemicals.
Understanding the display
Power
The Power button, when pressed, will begin the ice
making process. When pressed, while ON, will turn the ice
Light
Toggle between the three modes by pressing the light button
until you reach your desired lighting mode.
Clean
The cleaning cycle is initiated by pressing and holding the
stop once the cycle has been completed.
49-9000029 Rev. 3
Do not use solvents or chemicals.
Making Ice Add Water
Defrosting Cleaning
Clean Light
Hold 3 Sec
Defrosting
will run a rinse cycle to defrost the ice maker and then start
making ice again.
Indicator Lights
unit needs more water before it can cycle to make ice or clean.
WiFi
connect to their Opal and control it from their Android or iPhone.
Do not use solvents or
Power