1. Manuals
  2. Brands
  3. TEH Manuals
  4. Sander
  5. LS401
  6. Quick start manual

TEH LS401 Quick Start Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Cordless Sander
LS401 LS402
Tools for Every Home

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LS401 and is the answer not in the manual?

Questions and answers

Summary of Contents for TEH LS401

  • Page 1 Cordless Sander LS401 LS402 Tools for Every Home...
  • Page 2 Model LS401 LS402 Rated Voltage DC 20V DC 20V Motor Brushless Brushless No Load Speed 8000-12000r/min 8000-12000r/min Sanding Paper Size 110*100MM 125MM Battery Compatible Battery LB2.0Ah/LB4.0Ah LB2.0Ah/LB4.0Ah On/Off Switch Battery Release Button Speed Control Dust Bag...

  • Page 3: Electrical Safety

    e) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. f) If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply.

  • Page 4: Use And Handling Of The Cordless Electrical Power Tool

    SPECIAL SAFETY DIRECTIONS FOR BATTERY-OPERATED TOOLS l) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. a) Ensure that the device is switched off before inserting the battery. Inserting a battery into a n) Use the power tool, accessories and tool bits etc.

  • Page 5: Residual Risks

    e) Connect the charger only to a socket with an earth. Ensure that the mains voltage matches the a) Cuts specifications on the charger rating plate. Risk of electric shock. b) Ear damage if working without ear protection. f) Disconnect the charger from the mains before closing or opening connection to the battery / c) Damage to your health caused by swinging your hands and arms when operating the appliance power tool / device.

  • Page 6: Installation Instruction

    INSTALLATION INSTRUCTION Removing and reinstalling the skirt WARNING WARNING Do not use the tool without the skirt. Otherwise dust is scattered all over. You can choose one of 12 directions of the skirt in accordance with your purpose. Always be sure that the tool is switched off and the battery cartridge is removed To remove the skirt, remove the screw and remove the skirt with slightly opening it for both sides.

  • Page 7: Sanding Operation

    WARNING WARNING 1. Use only a TEH genuine sponge pad, felt pad or wool pad (optional accessories). 2. Always operate the tool at low speed to prevent work surfaces from heating Never switch on the tool when it is in contact with the workpiece, it may cause an abnormally.

  • Page 8: Maintenance

    To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by TEH Authorized Service Centers, contact number： fax number： always using TEH replacement parts.

This manual is also suitable for:

Ls402

Table of Contents