Download
Share
Print this page
  1. Manuals
  2. Brands
  3. NARIKA Manuals
  4. Industrial Equipment
  5. C15-2851-W0
  6. Instruction manual

NARIKA C15-2851-W0 Instruction Manual

High-accuracy monkey & hunter set
Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual
Instruction manual
C15-2851-W0
High-accuracy Monkey & Hunter Set
July 2022

Advertisement

loading

Related Manuals for NARIKA C15-2851-W0

Summary of Contents for NARIKA C15-2851-W0

  • Page 1 Instruction manual C15-2851-W0 High-accuracy Monkey & Hunter Set July 2022...

  • Page 2: Safety Precautions

    Safety Precautions Do not disassemble, repair, and remodel this product. The warranty will be void. Do not apply electric voltages over 4 V (maximum allowable input voltage) to the ball release unit (hereinafter, BRU). Otherwise, the electromagnetic coil of the unit may ignite and burn out.

  • Page 3: Description Of Each Part

    Description of each part Boom (in full-length) Ball release unit (BRU) Ball launcher Bipod Projectile Free-falling Object Fig. 1 Assembled apparatus How to set up 1.Securely unite the upper boom with the lower boom using two of screw with a built-in knob to assemble the full-length boom.
  • Page 4 3. Find the U-shaped bracket mounted on the upper boom. To fix each leg at a proper angle to the upper boom, slide each leg fully into the U-shaped bracket and firmly screw it with two screws with a built-in knob (see Fig. 3). If not attached at first, slide the two legs into the bracket and fix them by the screws.
  • Page 5 object electromagnetically. The threshold voltage value ought to be between 1.2 to 2.5V. 5. Set the output voltage slightly over the detected threshold so that the object can barely stick to the iron core. Do not apply voltage exceeding DC 4V (maximum input voltage) to BRU. Do not apply voltage well over the abovementioned threshold voltage value.
  • Page 6 Fig. 8 How to launch (fire) a Projectile Do not look into the barrel or aim at something. Make sure the area in front of the ball launcher is clear. Pressing Trigger/Stopper Button only with index finger is highly recommended. Be careful not to catch finger(s) in between the latch and the knob when SFP gets back.

  • Page 7: Troubleshooting

    2. Example of Projectile Trajectory (when launched horizontally): Troubleshooting Note this is a factory-adjusted product that should work successfully without any adjustment on site. Nevertheless, in case the projectile rarely hits the free-falling object, please carefully read the precautions again and go through the below adjustment procedure as needed.
  • Page 8 loosen the knurled screw (left) counterclockwise, [3] tighten the knurled screw (right) clockwise as far as you can, and then [4] tighten the screw knob to lock the barrel again. Launch the projectile again to check if the projectile hits the string. If not, repeat above procedure. 6.
  • Page 9 Check if the projectile successfully hits the free-falling object. Screw with a built-in knob (1) (Closer to Trigger/Stopper Button) Screw with a built-in knob (2) (Further from Trigger/Stopper Button) Fig. 12 www.global.narika.jp...