anko 42788591 Instruction Manual
anko 42788591 Instruction Manual

anko 42788591 Instruction Manual

Solar powered 200 led blue icicle lights

Advertisement

SOLAR POWERED 200 LED
BLUE ICICLE LIGHTS
These instructions are for your safety. Please read through them thoroughly
before use and retain for future reference.
Introduction
The solar light consists of a solar cell, a rechargeable battery and LED lights. All these are
preassembled. During the day time, light from the sun charges up the batteries. At night,
the energy stored in the batteries is used to power the light. No other power or connections
are required. The length of time the light stays on is dependent on how much sunlight has
been received during the day.

Installation Instructions

1. This light set is designed for use OUTDOORS in an open (unshaded) location.
2. Do not position or place near barbecues, heaters or any other direct sources of heat.
3. The solar panel should be located where sunlight can fall directly on the panel.
Shadows from buildings, trees, walls/hedges and similar objects should be avoided if
possible as these will reduce performance.
4. Try to avoid locations where light from other sources (e.g. streetlights, floodlights etc.,)
may affect the PIR sensor. This product is designed only to illuminate in dark
conditions, and may not operate if light reflects on the panel.
5. This product can be left outside in rain, but should not be exposed to water jets or
immersed. For optimum lifespan, the solar panel should be stored indoors during extreme
weather conditions (prolonged snow and frost).

User Instructions

1. Remove all packaging before use and dispose of safely.
2. Ensure there are no pipes or mains cables immediately underneath, then fix the solar
panel assembly to the ground by the anchor spike.
3. Turn the ON/OFF switch at the bottom to "ON".
4. Place the product at the desired locations. Ensure the cables are routed so that they
do not present a tripping hazard.
5. Press 'MODE' switch on solar panel to select function: 'Steady on' or 'Flashing'.

Battery Replacement

The battery is non-replaceable. DO NOT attempt to replace it.

Bulb Changing

The light set is constructed with non-replaceable bulbs. DO NOT attempt to replace any
of the bulbs in the light set.

Warning

This product is designed for use OUTDOORS ONLY .
Remove all packaging before use.
This product is not a toy, keep out of reach of children.
This product has small parts, which may pose a choking hazard if detached.
The end point of the ground stake is sharp. Please do not allow children to play with
the anchor spike.
Keep away from fire and sources of heat.
Some condensation may form inside the unit or solar panel in cold conditions. This is
normal and can be ignored.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 42788591 and is the answer not in the manual?

Questions and answers

Summary of Contents for anko 42788591

  • Page 1 SOLAR POWERED 200 LED User Instructions 1. Remove all packaging before use and dispose of safely. 2. Ensure there are no pipes or mains cables immediately underneath, then fix the solar BLUE ICICLE LIGHTS panel assembly to the ground by the anchor spike. 3.
  • Page 2 Direct sunlight is required to charge the battery. Assembly diagram Keycode: 42788591...

Table of Contents