Schmid RAPID Secure XL Operation Instructions

Operation instructions
RAPID ® Secure XL (screw-in tool)

Technical data:

Power tool adapter
Max. lenght (incl. Bit) x diameter
Weight
Bit adapter
Maximum torque
Power tool adapter (2)
Bit: T40 | 50 mm lenght - 5/16"
Suitable screws
ø 8 mm Rapid /GPR washer head
® ®
ø 8 mm Rapid SuperSenkFix
®
ø 12 mm Rapid Dual
®
ø 12 mm Rapid T-Lift
®

Scope of application:

The RAPID Secure XL screw in tool was designed for quick, safe and
®
effortless installation of long timber construction screws with a rotary
drill.
The RAPID Secure XL screw-in tool allows safe overhead and angled
®
screwing. The screw's head is reliably fixed in the screw-in tool and
results in longer life of the bits.
• First familiarize yourself with the operating instructions for RAPID
Secure XL and the power tools you are using.
• The user alone is liable for damage caused by improper use.
• The generally accepted rules and regulations for the prevention of
accidents must be observed.
1 | 09/22
Hex type 11,5 (for 13 mm standard-chuck)
207 mm x 46 mm
680 g
Hex type 5/16"
130 Nm
Holding element (4)
Bit-protrusion length L
25.5 mm ø 10 mm Rapid
25.5 mm ø 12 mm Rapid
25.5 mm
25.5 mm
®
Rear clamping screw (5b)
Adjusting screw - inside (6)
Front clamping screw (5a)
Bit: T 50 | 50 mm lenght - 5/16"
Suitable screws
/GPR countersunk head
® ®
/GPR
countersunk head
® ®
ø 10 mm Rapid SuperSenkFix
®

Bit setup:

• At first loosen both clamping screws (5) slightly and remove the
inserted bit.
• Clamp the power tool adapter (2) and loosen the axial adjusting
screw (6) using a 3 mm allen key (picture A).
• Adjust the desired protrusion length L and fix the bit with the
clamping screws (5). Start tightening the front clamping screw (5a).
• After fastening the first 100 operations, tighten the clamping screws
(5) again.
A
Drive shaft (1)
Bit (3)
Bit-protrusion length L
28.0 mm
28.0 mm
28.0 mm
www.schrauben.at