JVC LT-Z37DX7 Instructions Manual page 21

Technical information
When "Auto" is selected in Zoom, the aspect ratio will turn to the ratio obtained from the information the TV
received.
 The aspect ratio will turn to the ratio obtained from WSS (Wide Screen Identification Signal), video signal, or
control signal of the external devices. Without receiving the aspect information, it will be the setting in Auto in
Zoom menu. (Regular or Panoramic or 14:9 Zoom) (P.31)
Not available in PC mode.

What is "Eco Sensor"?
You can adjust this TV so that the screen automatically adjusts to the optimum contrast of light and dark according
to the brightness of your room. This function reduces eye strain and the power consumption of this TV.
 Set "Eco Sensor"  "Eco Sensor" (P. 24)
Make sure not to block the Eco Sensor on front of the TV (P. 5)

 Using "Demo" in "Eco Sensor" You can display the effect of the "Eco Sensor" on the screen
To fully reduce eye strain and the power consumption of this TV. Set to the following functions.

Eco Sensor: On or Demo (P. 24)
Smart Picture: On (P. 31)
Eco Sensor
Dark
37
Auto in "Zoom"
Light
(continued)
Most conventional LCD panel uses 50 frames per second (50Hz) or 60 frames per second (60Hz) to display an
image which needs long holding time (time it takes to display single frame), causing blurring or ghost images when
there is rapid or complex movement across the screen – a phenomenon common to all LCD panels.
This TV is equipped with JVC's original "Clear Motion Drive" technology, which displays two frames (the original
plus the new interpolated frame) in the time a 50Hz or 60Hz set displays a single frame. Resulting to double the
typical rate, 100 frames per second (100Hz) or 120 frames per second (120Hz) and halve the holding time without
reducing brightness or contrast. By using this technology you will be able to reduce blurring or ghost images when
there is rapid or complex movement across the screen.
By using "Demo", you can display the differences between conventional LCD (50Hz or 60Hz) and LCD panel
equipped with "Clear Motion Drive".
*1 To simulate Moving image of conventional LCD, the TV will display two same frames at a time.
Note : The illustrations are emphasized to make clear differences between LCD panel equipped with "Clear Motion Drive"
and conventional LCD.
Set "Demo" to "On" "Off".

When set to "On", it automatically enters demonstration every time no operation is made for approximately

3 minutes. To stop automatic demonstration, set "Demo" to "Off".
Clear Motion Drive
Moving image of LCD panel
equipped with "Clear Motion Drive"
(100 or 120 frames per second)
Moving image of 50Hz or 60Hz
conventional LCD (50 or 60 frames
per second)*1
 "Demo" (P.30)
The "DynaPix" ticker will run
right to left
You can confirm the differences
of the two LCD's with actual
moving images
38