Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for XAG RD24412
- Page 1 User Manual （4D Imaging Radar）...
-
Page 2: Main Features
With an embedded gimbal motor, this 4D Imaging Radar is capable of dynamic scanning and fixed angle scanning. Model: RD24412 Main Features: Distance Measurement Range: 1.5m~40m Range Resolution: 0.75m... -
Page 3: Specifications
2. Specifications Table 1. Main Specifications Parameter Testing Condition Typical Unit Value System Transmit 24.05 24.25 Frequency Transmit Power Average/Peak EIRP Modulation FMCW Refresh Rate Measurement Distance Range @FOV: Azimuth: ±40°; Pitch Angle: +90°~-45° Distance Accuracy Non-tracking Point Target ±0.1 Velocity Range Away from Target: “-”;... -
Page 4: Operating Conditions
Resolution Angle Resolution Non-tracking Point Target ° @Azimuth: ±40° Antenna Azimuth (-3dB) ° Beamwidth Pitch Angle (-3dB) ° Antenna Gain Interface CAN-FD Communication Speed Mbps Structure Dimensions W*L*H 87*87*153 Material Radar Housing PA66+30%GF Rear Cover Cast Aluminum Weight 3. Interfaces The interface on the Dynamic Imaging Radar for external communication is CAN-FD, working with a 6PIN connector defined as follows. - Page 5 Table 3. Operating Conditions Parameter Testing Condition Typical Unit Value Operating Battery Powered Voltage Power @48VDC Consumption Static Power @48VDC Consumption Operating °C Temperature Storage °C Temperature Shock 500m/s²@6 ms half-sine(10 x shock each in +/-X/Y/Z dir.) Vibration 20m/s² peak at 10Hz/0.14m/s² peak at 1000Hz Protection IP67 (10cm below the surface of water) Rating...
- Page 6 Export 24GHz Radar CE/FCC/KCC Certification FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
-
Page 7: Radiation Exposure Statement
20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: 2A46G-RD24412”. The grantee's FCC ID can be used only when all FCC compliance requirements are met. - Page 8 The end product shall bear the following 15.19 statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the RD24412 and is the answer not in the manual?
Questions and answers