SyberSense XPK-01 Manual

XPK-01 Keyfob Sensor Manual
Part number: XPK-01
Description
The XPK-01 keyfob is a battery operated wireless handheld
alarm sensor. When a button is pressed, the associated
command is sent to the panel.
Notes
The keyfob requires that each button is programed with

the desired command (Away, Stay, Disarm, and SOS).
The keyfob has a range of up to 100 ft. Metal, floors, and

appliances may affect the range.
Important safety instructions
Before you program this sensor, be sure to:
 Read, keep, and follow all instructions.
When there is a low battery, replace with a compatible

lithium ion battery.
© 03MAR 20 SyberSense
Setup
Use the panel to add and setup the keyfob.
To add the keyfob to the panel:
1. Add the sensor to the panel.
2. Once added, test the sensor.
Look at the panel, and then press Away/Stay.
Notice that the panel begins to arm.
Note: Testing all sensors to the alarm monitoring station
is strongly advised.
Button function
The keyfob has 4 buttons. Once the keypad is added to the
panel, the buttons control the arming and disarm features of
the panel.
Away: When tapping this button, the panel arms in Away
mode.
Stay: When tapping this button, the panel arms in Stay mode.
Disarm: When tapping this button, the panel is disarmed.
SOS: When tapping this button twice within 3 seconds, the
keyfob sends a panic notification to the alarm monitoring
station.
Battery replacement
The XPK-01 keyfob requires a CR2032 battery. Once the
battery is low, the panel displays a low battery icon next to the
sensor in the devices list. The battery must be replaced within
7 days of the first low battery notification. If the battery is not
replaced within 7 days, the sensor may not function properly.
WARNING: If an incompatible replacement battery is used, or
the battery is installed incorrectly explosion or damages may
occur.
1 / 3 DOC ID – 1707 • Rev 01