Toro 115-4029 Installation Instructions Manual page 2

1. Flange nuts
7. Remove and save the 2 flange nuts securing the air
cleaner (Figure 2).
8. Remove and discard the air cleaner and gasket from
the carburetor.
2
Installing the Intake Pipe
Parts needed for this procedure:
1 Intake pipe
1 Gasket
1 Breather tube
Procedure
1. Install a new gasket and intake pipe onto the
carburetor using the flange nuts you removed
previously (Figure 3), and torque the flange nuts to
52 to 69 in-lb (6 to 7.5 N-m).
Figure 2
2. Breather tube
1. Carburetor stud
2. Gasket
2. Install the new breather tube between the intake pipe
and the engine (Figure 4).
2
Figure 3
3. Intake pipe
4. Flange nut
Figure 4