Summary of Contents for SCANDYMET STFX
- Page 1 Electrical immersion heaters Installation and maintenance instructions STFX STIX SCAX SMSX www.scandymet.com...
- Page 2 Index: Page 3-4. Before installing Page 5. During installation Page 6. Maintenance and control of immersion heater in service Page 7. Attach the fastener Page 8. Cleaning the heaters www.scandymet.com...
- Page 3 Process tank is equipped with a low solution level detection shut-down device. Confirm the line and heater voltage agree and the cubicle is locked for heating capacity. If voltage or material is incorrect, do not install or operate heater. www.scandymet.com...
- Page 5 If not, overheating can occur at min. level, Heating which may be a fire hazard. zone (A) In service, heaters should be protected from contact with moving parts, anodes, cathodes, or any other source of current. Heating zone (B) www.scandymet.com...
- Page 6 The supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped (flexible heaters). If the supply cord is damaged, it must be replaced by manufacturer, its service agent or similarly qualified person in order to avoid a hazard (tubular heaters). www.scandymet.com...
- Page 7 (make sure that the part of the cable are closer to the connection box as the pictures shows) and place it on the bath edge. Be sure that the heating part of the heater is under the solution level before Switch on the heater. www.scandymet.com...
- Page 8 A soft brush or gloved hands are recommended to remove build-up from the element. Be cautious while cleaning to avoid damage. Do not remove the over heat protection when cleaning the heater. For further questions please contact: customer@scandymet.com Tel: +46-270 19310 Fax: +46-270 10656 www.scandymet.com...
Need help?
Do you have a question about the STFX and is the answer not in the manual?
Questions and answers