Page 1
Cordless Vacuum Cleaner Instruction Manual READ AND SAVE THESE INSTRUCTIONS THIS MACHINE IS INTENDED FOR HOUSEHOLD USE ONLY Do not use near Do not store near Do not pick up water open flames heat sources or liquids Do not pick up Do not put hands Do not place on SHENZHEN ZAPADOS TECHNOLOGY CO.,LTD...
Important Safety Instructions 14. Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts. Do not point the hose, wand or tools at your eyes or ears or put them in your mouth. BEFORE USING THIS MACHINE READ ALL INSTRUCTIONS AND CAUTIONARY 15.
Part Name Speed Control Button Motor Unpack Battery Button Primary Filter Strainer Vent High efficiency Strainer Power On / Off Metal Filter Strainer Unpack Dust Cup Button Dust Cup Buckle Metal Tube Locker Metal Tube Power Brush Locker Power Brush Battery Pack Electrode Pin DC Socket...
Assembly Click Click Click Docking station installation Ensure no pipe work (gas, water, air) or electrical cables, wires or ductwork are located directly behind the mounting area. The position of stand is jut the height of machine. 1. Use stick or screw to fix the stand...
Charge the Machine Emptying the clear bin Plug the adapter into the a wall outlet and plug the DC jack into the DC socket of the Battery • Empty as soon as the dirt reaches the level of the MAX mark – do not overfill. •...
Maintain the Machine Looking for blockages • Ensure the machine is disconnected from the charger before removing the clear bin. •The motor will pulse when there is a blockage. Please follow the instructions belowto locate • Remove the tube , floor tool and battery pack. the blockage: •...
Page 8
3. Take out the filter 6. Install the Dust Cup Click 1. The protrude angle of motor 2. Hold the Dust Cup and must inset the sunken of Dust Upward Wash filter with cold water at least once a month. Cup.
Direct Drive Cleanerhead: Cleaning Troubleshooting obstructions or replace brush 1. Empty the dirt cup. 2. Clean the HEPA filter. Suction gets weak 3. Check if the dust cup is installed correctly. 1. Check if the brush (especially the bearing part) is stuck by hair. 2.