Nicolas Holiday GE Winterberry Color Choice Assembly Instructions

Winterberry Branch Tree
®
Color Choice LED Technology
®
Assembly Instructions
CAUTION: EXERCISE CARE WHEN UNPACKING AND ASSEMBLING
Nicolas Holiday Ltd. thanks you for purchasing this pre-lit Christmas tree.
Should you have any problems with your tree, visit us at
www.geholidaylighting.com
You can call our toll free number at 1-877-398-7337.
Check our website for latest service hours and assembly instruction videos.
WARNING:
Risk of fire and electric shock. Disconnect light set from power before starting.
1) Keep wires clear of being pinched or cut during assembly or installation.
2) Do not press or grasp bulbs during assembly or installation.
3) Before starting make sure stakes are clear of underground:
sprinkler, telephone and power lines.
4) Please read all instructions and warnings included with this product before using.
1. Carefully unpack, removing any bubble wrap and inspect the
contents of your tree. {Fig. A}
A
Top section
Bottom section
Instruction manual
B
90
The tree stand should be open and set at 90 angle. Remember to tighten
the thumbscrew after connecting bottom section and tree stand. See {Fig. B}
Untie red twist-tie to release branch panels.
Gently position any branches that do not fall into place.
Your assembled tree may be heavy and difficult
to move when done, so place the stand in desired
location before assembling.
Secure in place using the (4) metal stakes.
2. When you connect two tree sections, it is
important that you align the mark on the
tree poles. See {Fig. C}
Assemble section by section.
Disconnect the decorative item from the power source before
performing any maintenance or cleaning.
Indoor/ Outdoor
120V
THIS IS NOT A TOY, FOR DECORATIVE USE ONLY.
GE is a trademark of General Electric Company
and is under license by Nicolas Holiday Ltd.
©2021 Nicolas Holiday Ltd.
9 F., No. 37, Guangfu North Rd.,
Taipei, Taiwan 10560 All rights reserved.
21149LO
Printed in China
8.25"x11.25"
for more information.
Middle section
Metal stand and 4 stakes
Thumbscrew
C
TREE ASSEMBLY DIAGRAM
5 FT
Top
section
Middle
section
Bottom
section
Tree Stand
SCHEMATIC DIAGRAM
3. To electrically connect the lighted sections:
First, locate the 2 white connector cord tags between each section.
Then fully insert the 2-pin polarized male and female connectors.
Fully screw on the cap to secure connection.
4. To illuminate, find and unhank the long lead wire from the bottom
section.
Fully insert the direct plug-in adapter into a working GFCI outlet or an
outdoor rated extension cord.
NOTE: Hammer/Mallet may be required for stakes
Tree Sections
5 ft tree 3
Troubleshooting Tips
If one section of your tree does not illuminate, check that section for cut or
damage wires or that all electrical connections on tree are made.
Due to unique construction of the light sets, the individual LEDs are not
replaceable. The light sets are designed for continued operation even if an
individual LED fails to light.
IMPORTANT: Store your carton neatly in a cool, dry location protected
from sunlight to prolong the tree life and to better keep the light sets in
working order. Do not place a heavy load on the carton to avoid damage
to or crushing the carton and tree inside.
NO Spare Bulbs
FUNCTION LIST
1. Steady White
2. Steady Multi
3. SLO-GLO
4. White SLO-GLO
5. Multi SLO-GLO
6. White Flashing
7. Multi Flashing
8. Change/Twinkle Flashing
9. Off ( N )
control box
OPEN
Tree Stand Approx. Asm Time
Metal 5 – 10 minutes