Turning Technologies MobiView Quick Start Manual

WorkSpace PC for New Users
WORKSPACE PC FOR NEW USERS
Before Class
Charging the MobiView
The MobiView should arrive partially charged and ready to be installed. Turning Technologies recommends that MobiView and
its digital pen are both fully charged prior to use in the classroom.
1
Carefully remove the plastic tab from the digital pen and place the pen in the recharging pen holder.
2
Remove the MultiHub from the back of the MobiView. For convenience, store the MultiHub in the holder on the
charging stand.
3
Place the MobiView on the charging stand.
4
Plug the USB cable into the power adapter and plug into the wall outlet. Allow approximately eight (8) hours to fully
charge the battery.
Alternatively, the MobiView can be charged by connecting the device to a computer via USB cable. Allow
approximately 12 hours to fully charge the battery if using this method.
TIP
You can use the MobiView while it is charging.
Using the Digital Pen
1
Rest your hand on the MobiView. Do not touch the digital pen to the MobiView's surface; i.e. hold the digital pen as you
would a stylus.
2
Turn the digital pen's "rocker" buttons away from your fingers.
3
Single-tap the digital pen to the MobiView. This is equivalent to a left-click with a mouse.
Double-tap the digital pen to the MobiView. This is equivalent to a double left-click with a mouse.
Alternatively, use the digital pen's rocker buttons to make left-clicks and double left-clicks.
Pairing the MobiView with the MultiHub
The MobiView communicates with Turning Technologies software via the MultiHub. The MultiHub is a USB device stored in
the charging stand or on the back of the MobiView.
IMPORTANT
MobiView is compatible with the following software:
WorkSpace
l
Flow
l
MobiView is NOT compatible with Insight360
turningtechnologies.com/training-support
™
.
1