Airigami AIRBUS A220-300 / KOREAN AIR Quick Start Manual

For best results we recommend this package be printed on Glossy 80lbs paper stock.
Assemble sections in the following order: 1. Gear > 2. Engines > 3. Wings >
> 4. Hor. Stab. > 5. Nose > 6. Fuselage.
1. Cut out shape to remove yellow areas.
2. Fold back-to-back along lines where indicated.
8. Place shaded Nose area 17 inside to forward Fuselage at point 18.
9. Stick together the two Fuselage sides around the Nose area and Wing tabs.
10 Insert Hor. Stb. tab 19 into rear Fuselage at point 23.
This is a genuine, official Airigami design. This design is provided free-of-charge - you
should never, ever pay for this design. However, we strongly urge you to consider donating to Airigami at www.papieravion.org. Airigami was established so that the joy of airline modeling
can be available to everybody. Please consider making a donation of $5, $20, $50 or whatever you can to help keep Airigami alive and, best of all, free.
0 05 10
0 05 10 15 20 25 30 35
AIRBUS A220-300 / KOREAN AIR
Paper-based scale model design system Copyright © 2021 — Airigami / Airline designs and logos are reproduced for Fair Use
educational and informational purposes. USE OF THIS TEMPLATE FOR FINANCIAL GAIN IS PROHIBITED.
3. Fold in tabs 20 and 21 inside the Fuselage.
These tabs act as ballast to balance the model
and are Optional (can be removed if desired).
4. Cut out the shaded area 22 in the center
Fuselage and remove.
5. Cut out the yellow area 23 at the rear Fuselage
(near the Vertical Stabilizer) and remove.
6. Apply glue to non-printed surfaces. Do not stick
together until step 9.
7. Place Wing tab 14 inside the center Fuselage
between points 15 and 16.
15 20
40 45 50 55 60 65 70 75
25 30 m
80 85 90 95 100ft
7GKAL21L05