Alignment of the transponder(s) ............... 5 Connecting a LaserTrack Flare with 1 front transponder........6 Connecting a LaserTrack Flare with 2 front transponders ........7 Connecting a LaserTrack Flare with 3 front transponders ........8 Connecting a LaserTrack Flare with 1 rear transponder ........9 Connecting a LaserTrack Flare with 2 rear transponders ........
IMPORTANT INFORMATION Install LaserTrack Flare in your vehicle fi rst and make sure the transponders are installed according to the instructions. After that, register and confi gure the system on the web page www.laser-track.com under 'My LaserTrack'. The plugs of the transponders are equipped with arrows. Make sure both arrows are facing each other before pressing the plugs together.
LOCATION OF THE TRANSPONDER(S) In the centre of the vehicle, preferably above the With one front transponder; license plate. Equally divided between the two headlights and With two front transponders; the license plate. Equally divided between the two headlights With three front transponders; and the license plate.
INSTALLATION OF THE TRANSPONDER(S) Due to the extremely compact dimensions of the LaserTrack Flare transponders, no mounting brackets are included. It is recommended to bond the transponders into grille or ventilation apertures with a two-component kit or glue (for example: Würth Replast Easy plastic glue or Innotec Topfix).
TECHNICAL SPECIFICATIONS • Power supply: 10 – 16V • Power consumption at 12V. when idle Main unit: 60mA Transponder: 70mA • Power consumption when active Main unit: 60mA Transponder: 140mA • Fuse: 5A • Temperature range: -20°C - +70°C • Dimensions in mm.
Page 12
Zuidergracht 21 | 3763 LS Soest | the Netherlands | info@tracktechnologies.nl | +31 (0)35 760 5760 www.laser-track.com...