Panasonic Lumix DMC-FS15P Service Manual page 35

Service Manual
Diagrams and Replacement
Parts List
Digital Camera
Model No.
DMC-FS15P DMC-FS15EG
DMC-FS15PC DMC-FS15EP
DMC-FS15PR DMC-FS15GC
DMC-FS15PU DMC-FS15GJ
DMC-FS15EB DMC-FS15GK
DMC-FS15EE DMC-FS15GN
DMC-FS15EF DMC-FS15GT
Vol. 1
Colour
(S)...........Silver Type (except PC/PR/EF/GJ)
(K)...........Black Type
(A)...........Blue Type (except PR/EF/GJ/GK/GN/GT)
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. Flash Top P.C.B. .................................................................... S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S4. Schematic Diagram .................................................................. S-4
S4.1. Interconnection Diagram ....................................................... S-4
S4.2. Flash Top Schematic Diagram .............................................. S-5
S4.3. CCD Flex Schematic Diagram .............................................. S-6
S4.4. Lens Flex Schematic Diagram .............................................. S-7
S5. Print Circuit Board .................................................................... S-8
S5.1. Flash Top P.C.B. .................................................................... S-8
S5.2. CCD Flex P.C.B. .................................................................... S-9
S5.3. Lens Flex P.C.B. .................................................................. S-10
DSC0902007CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S6. Replacement Parts List .......................................................... S-11
S7. Exploded View ....................................................................... S-16
S7.1. Frame and Casing Section.................................................. S-16
S7.2. Camera Lens Section.......................................................... S-17
S7.3. Packing Parts and Accessories Section (1) ........................ S-18
S7.4. Packing Parts and Accessories Section (2) ........................ S-19
S-1
" mark.
Circuit name being connected.
This signal is connected
OFTR FEP
to the FEP schematic diagram.
Name of Signal
HAVE THE SPECIAL CHARACTERISTICS