General Assembly Notes Assembly of the Edison Rail Lamp is performed in the same manner for both Edison Junior and Edison Senior Rail systems: the assembled lamp unit is mounted along the slot spanning the top of the rail. Rail modesty side panels (and water tray, Edison Senior only) must be removed prior to mounting (see below), and reinstalled after mounting accessories (steps 7 - 9).
Page 5
Edison Junior: Panel Removal Grabbing from the bottom of the screen, pull the screen away. The magnet that hold the panel in place will disengage and the panel will become separated from the frame. 5 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS...
Page 6
Pass the cables through the light rod (a) and slide the light rod over the cable and up to the lamp stem (b). Use the flat sections of the light rod to tighten fully into the bottom of the lamp using pliers (c). Light Rod (100mm) 6 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS...
Page 7
Pass the cables and light rod through the slot in the rail and then through the mounting lock washer. Secure the lamp stem to the rail by tightening the mounting nut with a 13mm wrench. 7 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS...
Page 8
(c.), applying even pressure around the perimeter until a snug and level fit is achieved. Thread Cutting Flat Head Screw M4 X 12mm 8 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS 8 TONIC INFILL NEIGHBORHOOD LIGHT ASSEMBLY INSTRUCTIONS...
Page 9
(b.). Make sure to connect red to red and black to black. Secure excess cables. Plug into power source and test (c.). Leave some slack in the power supply cable for the next steps. 9 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS...
Page 10
Edison Senior: Replace Water Tray Reattach the water tray to the rail using the set aside screws and washers from Step 2. Route the power supply cable out the end of the water tray as shown. 10 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS...
Page 11
Attach the panels that were set aside in Step 1 by lifting and clipping them onto the rail clips. Secure the panels to the rail using the #8-32x1/4 screws that were set aside with the panels (2x per panel). #8 X 3/4 (Not included with light) 11 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS...
Page 12
Connect the wires from the power supply to the wires on the light by inserting the cable into the wire splice connector (a.) and then snapping the connector closed (b.). Make sure to connect red to red and black to black. Secure excess cables. 12 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS...
Page 13
Edison Junior: Replace Panels Holding the bottom handle of the side panel, align the cutouts with the plug faces in the rail and push against the rail. Magnets will catch and secure the panel to the rail. 13 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS...
Page 14
Edison Junior: Plug in Power Once panels are installed, plug in the lamp into the outlet of the rail for power. 14 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS...