Crown Berman FS Series Instruction Manual

Thank you for choosing a Berman Safe - FS Series. Before operating your new safe, please read the user manual to ensure optimum performance.
1. FIRST TIME OPENING THE SAFE
a. Lift the bottom of the square
plate (plate P on Diagram 1
shown below - next to the
fingerprint sensor), then the
top, to remove plate.
b. Insert the key into the lock
and turn clockwise to open
the door.
2. INSTALLING THE BATTERIES
The safe requires 4 AA (1.5V/LR6)
batteries (included). Remove the
battery cover (located on the inside
of the door) and install the batteries
into the compartment. Make sure
that the batteries are fitted in the
right position to match the polarity.
Close the battery compartment.
Use of alkaline batteries is recommended.
3. PROGRAMMING YOUR FINGER
The safe can be opened by any
finger that has previously been
setup. To register your finger:
a. With the door open, press the
green button located on the
top of the door. The front light
will turn yellow and the
fingerprint reader is ready to
capture.
b. Place your finger on the
fingerprint reader within 5
seconds. Please register the
same finger three times. When
the front light turns green,
your fingerprint has
successfully registered.
If the light turns red and you
hear 3 beeps, the registration
failed. Please try again.
IMPORTANT:
To enhance the fingerprint
•
identification rate,
recommend the same finger is
programmed 3 or more times,
from different positions, as
shown in Diagram 2 of the user
manual.
We also suggest that you
•
register 2 fingers for each hand
programmed.
To avoid fingerprint reading
•
failure, we
cleaning your finger with a dry
cloth before placing it on the
reader. Also, keep the reader
clean from
humidity.
Always keep your finger steady
•
and press your fingertip when
scanning.
The little finger
•
recommended to be used for
fingerprint identification.
Avoid bright lighting exposure
•
been
on the top of the fingerprint
reader.
we
Berman Safes FS Series
NOTE:
The safe can record up to 100
fingerprints.
recommend
4. USING THE SAFE
To open the safe:
grease and
a. Press the button located on
the right
fingerprint reader. The yellow
light will turn on, indicating
is not
that the reader is ready to
operate.
b. Place your registered fingertip
on the fingerprint reader
within 5 seconds. If the
fingerprint is valid, the light
will turn green and the door
will open automatically. If the
authentication fails, the light
will turn red and you will hear
3 beeps.
To close the safe:
Close the door and press the button
to the right side of the fingerprint
reader. The door will lock itself
automatically.
side of the