Table of Contents
Advertisement
FCC Compliance Information
This device
complies
with Part 15
of
the FCC Rules. Operation is subject to the following two
conditions: (1)
this device may not cause
harmful interference, and
(2)
this device must accept any interference received, including interference that may
cause
undesired operation.
Changes or modifications not expressly approved
by
the party responsible for compliance could void the user's authority to operate
the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These
limits are designed to
provide
reasonable protection against harmful interference in a residential installation.
This
equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception,
which
can
be determined by turning the equipment off and
on, the user
is
encouraged to try to correct the interference by one or more of
the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
FCC SAR Statement
This
equipment complies with
FCC
radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific
operating instructions for satisfying
RF
exposure compliance. This transmitter must not be co-located or operating in
conjunction
with any
other antenna or transmitter.
The portable device is designed
to
meet the
requirements
for exposure to radio waves established by the
Federal
Communications
Commission
(USA).
These requirements set a SAR limit
of
1.6 W/kg averaged over one gram of tissue.
The highest
SAR value reported under
this standard during product certification.
Industry Canada (IC) Compliance Statement
This
device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's
licence-exempt
RSS(s).
Operation is subject to the following two conditions:
1.
This device may not cause interference.
2. This device must accept any interference, including interference that may
cause
undesired operation of the device.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End
user
must follow the specific
operating instructions for satisfying RF exposure compliance. This transmitter must not be co·located or operating in conjunction with
any
other antenna or transmitter.
The
portable device is designed to
meet
the requirements for exposure
to
radio
waves
established by the ISED.
These requirements set a SAR limit of 1.6
W/kg
averaged over one gram of tissue.
The
highest SAR value
reported
under this standard
during
product certification.
Avis de
conformite
aux normes
d'lndustrie
Canada
L'emetteur/recepteur exempt de licence contenu dans le present appareil est conforme aux CNR d'lnnovation, Sciences et
Developpement
economique
Canada
applicables aux appareils radio exempts de
licence.
L'exploitation
est autorisee aux deux conditions suivantes
:
1. L'appareil ne doit pas produire de brouillage;
2. L'appareil doit accepter tout brouillage radioelectrique subi,
meme
si le brouillage est susceptible d'en compromettre le fonctionnement.
Cet equipement est conforme aux limites d'exposition aux rayonnements d'ISDE etablies pour un environnement non contr0le. L'utilisateur
final doit suivre les instructions d'utilisation specifiques pour se conformer
a
!'exposition RF. Cet emetteur
ne
doit pas etre colocalise ou
fonctionner en conjonction avec une autre antenne ou un autre emetteur.
L'appareil
portable est coni;u pour repondre aux exigences
d'exposition aux ondes radio etablies par ISDE. Ces exigences fixent une limite DAS de 1,6 W
/
kg
en
moyenne
sur un gramme de
tissu.
Valeur
DAS
la
plus elevee rapportee selon cette norme lors de la certification du produit.
i'IJjJ··••tttt••···jl
~~••m~z~~•~•ntt•~ff~~.~~-~~~~m•~~~m~•~••·m*~**•~~&ttz~tta~~·
~~-~~nuz~m~~~•mAA~~&T•~~-~;~gm~T•m•~·•~~~m•~~•~•T•~~~••~m•
M~~~•m•m~•m•~~m~~•z•••~m•
~~-~-fttt~~~~~-m~I•-~•a•~m•~•~tt••~~ZTS•
Advertisement
Table of Contents
