Advertisement
Q) I have a Jack and every time I plug it into the system it triggers the system and won't reset, what do
I do?
A) On most occasions you will receive your Ramblegard configured to your call system and no changes
will be required, but if you are experiencing issues please follow steps below.
Firstly you will have to check the configuration of your system to confirm whether it is a stereo or mono
system, by either:
Confirming the brand of the system, for example Intercall, or
Checking the plug on an existing call button or accessory you have in the home.
If your existing device has 2 black rings on the jack pin, it is stereo (ensure the switch is at 'Stereo'); as
below example shows.
STEREO
If it has 1 ring, it is mono (ensure the switch is at 'Mono'); as below example shows.
MONO
Advertisement
Table of Contents
Summary of Contents for Ramblegard Jack R09-0023
- Page 1 Q) I have a Jack and every time I plug it into the system it triggers the system and won’t reset, what do I do? A) On most occasions you will receive your Ramblegard configured to your call system and no changes will be required, but if you are experiencing issues please follow steps below.
- Page 2 Secondly, you will have to check the switch on the right hand side of the Jack adaptor. This should be: ON if you are using the socket on the side of the Jack for a Call Button or another accessory; However, ...
Need help?
Do you have a question about the Jack R09-0023 and is the answer not in the manual?
Questions and answers