Safe-Strap SAFE-DOCK Instructions

SAFE-DOCK
Tool Needed: Phillips Screwdriver
Step 1
Prop shopping cart gate into
its raised position as shown
using a screwdriver or piece of
wood.
Step 3
Step 5
Insert one end of the replace-
ment harness into the harness
receiving slot.
SAFESTRAP.COM
©Copyright 2016 Safe-Strap Company, LLC. All rights reserved.
TM
Replacement Harness Instructions
Please Read All Instructions Before Beginning the Installation.
Pull the old harness through
the holes in the Safe-Dock.
Discard.
Secure by inserting the metal
plate into the harness's end
loop. Do the same on the other
side.
At Least Monthly...
Inspect Safe-Dock for damage
Check all fasteners for tightness to ensure safety
Clean Safe-Dock with mild detergent and a damp cloth
800.356.7796
Step 2
Find the two screws that se-
cure the harness to the Safe-
Dock. Remove the screws
and the metal plate. Do the
same on the other side.
Keep the screws and metal
plates for attaching the re-
placement harness.
Step 4 Lay the replacement harness out on the Safe-Dock.
The red release button should point towards the
handle of the shopping cart.
973.442.4623
• Secure the metal plate
to the Safe-Dock using the
screws from Step 1.
• Repeat on other side.
• Tighten all 4 screws.
info@safestrap.com
rev: 2016/01-cjf