Advertisement
PLEASE READ ALL INSTRUCTIONS BEFORE USING
iWST26
Adapter
LED on adapter will glow solid green when connected to power
2-blade polarized AC plug:
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
Press the POWER BUTTON to turn the massager on. The Power Indicator will light up on the control pad. Press again to turn the unit off. The Power indicator will turn off.
Note: The unit will automatically shut off after 15 minutes of use. Turn the unit ON again to resume operation. Always unplug the AC power cable after use.
Press and hold the UP ARROW BUTTON to move the neck massager up to the desired position. Release the button to stop. Press and hold the DOWN ARROW BUTTON to move the neck massager down to the desired position. Release button to stop.
Press the MANUAL KNEADING BUTTON once to start a kneading neck massage in a clockwise direction (the indicator light will turn on solid red). Press again to change to a counter-clockwise direction (indicator light will blink slowly). Press again to stop kneading.
Press the AUTO KNEADING BUTTON once to start a kneading neck massage in a clockwise direction (the indicator light will turn on solid red). The massage nodes will automatically change direction every 15-30 seconds. Press again to stop (indicator light will shut off).
Choose from 3 pre-set massage zones: Full, Upper, or Lower. The massage nodes will focus on your selected zone and the corresponding indicator light (Full, Upper or Lower) will turn on solid red while in use.
When the Shiatsu Massage Mode is active, press the LOCATE BUTTON to start or stop a spot massage. Use the Locate Arrows (up or down) to move the spot massage to your desired location.
Press the HEAT BUTTON once to start heat therapy (the indicator light will turn on and the massage nodes will turn red). Press again to turn off heat (indicator light will shut off).
Choose from 3 levels of intensity: Low, Medium, or High. Press the SEAT BUTTON once to set to Low. Press again to change to Medium, and press once more to set to High. Press a fourth time to turn off.
When using electrical products, especially when children are present, safety precautions must always be followed.
READ ALL INSTRUCTIONS PRIOR TO USE.
TO REDUCE THE RISK OF ELECTRICAL SHOCK;
TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC SHOCK OR PERSONAL INJURY;
IF YOU ARE PREGNANT OR HAVE AN ILLNESS, PLEASE CONSULT WITH YOUR DOCTOR BEFORE USING THIS DEVICE.
PLEASE READ ALL THE INSTRUCTIONS CAREFULLY PRIOR TO USE.
Consult with your doctor before use, if;
SAVE THESE INSTRUCTIONS
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
The device comply with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
CAN ICES-3 (B) / NMB-3(B)
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of one (1) year from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI will repair or, at its discretion, replace this product without charge. This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center authorized by Customer Service.
If service is required, please contact Customer Service at ihome.com/support to obtain a Return Authorization Number and shipping instructions. A copy of the sales receipt is required to validate in-warranty coverage.
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover
This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original purchaser. In no event will SDI or any of its affiliates, contractors, resellers, their officers, directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental damages, any lost profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Your acknowledgment and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your SDI product.
© 2021 SDI Technologies, Inc. All rights reserved.
Questions? Visit www.ihome.com
Printed in China
iWNS26-071621-A
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download iHome SHIATSUMASSAGE LOUNGER iWST26 Quick Start Guide
Advertisement
Need help?
Do you have a question about the SHIATSUMASSAGE LOUNGER iWST26 and is the answer not in the manual?
Questions and answers