NYZ Apollo1 Manual

Product Overview

Bluetooth Connection

1. Pick up the two earbuds from the charging case. Pull off the protective film.
   
   
2. Put them in and take them out.
   
   
3. Turn on Bluetooth of the device, search for the bluetooth name: Apollo 1, click it to connect.
   
   The white light blinks for reconnect
   
   One earbuds white light blink quickly when paired
   

Disconnection

NOTE:
When you take out the earbuds from the charging case, they will connect with the most recently connected device.

When You Just Use To The Left Earbuds

When you using the left earbuds alone for the first time:

1. Take out the left earbuds
   
   
2. Select the new search for the bluetooth name: Apollo 1, click it to connect.
   

NOTE:
When you take out the left earbuds from the charging case after first time used the left earbuds alone, they will connect with the most recently connected device.

Tap Operation

Power on: White light holding 1 seconds

• Take out from case (Automatic)
  
  
• Hold MFB on each earbuds for 5 secs (Manual)
  

Power off: Red light holding 1 seconds

• Place in case (Automatic)
  
  
• Hold MFB on each earbuds for 5 secs (Manual)
  

NOTE:
The earbuds will automatically shut down after entering BT pairing for 2 minutes.

Charging And Working Time

	Fully charged in 1.2 hours
	8 hours for playtime

	Fully charged in 2 hours
	Provide 4 times charging for earbuds

Reset

The earbuds needs to be reset in the following situations:

• The earbuds cannot be paired automatically.
• The earbuds cannot be connected to bluetooth due to in correct operation.
• Try resetting when one headset is not working but the indicator is charging properly.
• Mismatch of headset connected devices.
• You can try to reset it in any case when it is not working.