Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Turnstiles SG Series
Summary of Contents for Turnstiles SG Series
- Page 1 CONTROL MODULE User's Manual SG/BA3/BR2/GA SERIES DEVICES...
- Page 2 Complete documentation: • GENERAL INFORMATION • PEDESTRIAN TRAFFIC CONTROL • DEVICE • CONTROL MODULE • MONTAGE • MAINTENANCE AND SERVICE • TECHNICAL DRAWINGS...
-
Page 4: Table Of Contents
PARAMETERS MENU ..................................................6 SETTINGS MENU ....................................................6 PICTOGRAMS CONFIGURATION ..............................................7 LICENSE MENU ....................................................7 TEST MODE ......................................................8 SG SERIES DEVICES ....................................................8 DESCRIPTION OF THE CONTROL MODULE TERMINALS ....................................8 SETTINGS MENU ....................................................9 ZERO POSITION CONFIGURATION ............................................9 CALIbRATION ....................................................10 FIRST RUN ......................................................10 bA3/bR2/GA SERIES DEVICES ............................................... -
Page 5: Module's Software
CONTROL MODULE MODULE’S SOFTWARE Device’s control logic is controlled by the device manufacturer’s software. The manufacturer grants licence to using the software only in cooperation with the purchased device and in order to control it. The abovementioned licence is granted by the manufacturer for products purchased at the authorised distributors only. -
Page 6: Main Screen
CONTROL MODULE MAIN SCREEN The main led screen is displayed when the power supply is on. On the left, the queue status is displayed (Q0 – queue for left direction, Q1 – queue for right direction). Errors are displayed in the upper right corner. Possible errors are: •... -
Page 7: Pictograms Configuration
CONTROL MODULE SETTINGS MENU Feedback signal type This setting defines the type of feedback signal emitted by the device. Possible confi- gurations: • OPN/REC - a feedback signal is sent immediately after the passage is unlocked • CLS/END - a feedback signal is sent after the passage is locked •... -
Page 8: Test Mode
In devices of the BA3, BR2 and GA series the mode is used only in devices equipped in the rotor’s movement support system. Caution: While starting the test mode no person can be found within the device moving elements range. SG SERIES DEVICES DESCRIPTION OF THE CONTROL MODULE TERMINALS Symbol... -
Page 9: Settings Menu
CONTROL MODULE Symbol Function in the master driver Function in the slave driver IN10 mass - not used mass of the fire-fighting signal IN11 input of the optical sensor 6 not used IN12 mass - not used not used OUT 1-2 not used NO feedback signal for the left direction OUT 2-3... -
Page 10: Calibration
CONTROL MODULE CALIbRATION After entering the calibration submenu, we can change certain operating parameters of the control algorithm. To edit an item, press the encoder knob. Then, by turning it, increase or decrease the edited value. • k – influences the general movement speed If the arm has a tendency to pass the locked position and then to reverse, the parameter needs to be reduced;... -
Page 11: Settings Menu
CONTROL MODULE Symbol Description Feedback signal output for left direction. The output consists of 3 pins that offer NO and OUT 1-3 NC signal. Duration of the signal and moment of it’s occurrence can be configured in the driver’s settings Feedback signal output for right direction. -
Page 12: Calibration
In order to provide safety during first run, follow these rules: Before applying power to the device make sure that all cables are connected properly. Wrong connection of the encoder may cause the device to behave in an unpredictable way. Take extra safety precautions. www.TURNSTILES.us patrick.mcallister@turnstiles.us 303-670-1099...
Need help?
Do you have a question about the SG Series and is the answer not in the manual?
Questions and answers