Advertisement
DOG TRAINING COLLAR WITH REMOTE
MODELS: DTR500, 502, 503, 1500, 1502, 1503
CONTENTS
The following items are included in the package, as shown on the photo below; dog training
collar(s), USB charger(s), USB wire(s), USB adapter(s), long probes pair(s).
PREPARING THE DOG TRAINING COLLAR WITH REMOTE FOR FIRST
TIME USE
The dog training collar needs to be charged for 5-6 hours. A fully charged battery provides an
autonomy of 20 hours. Connect the small USB adapter to the USB wire, and the USB wire to the
USB charger. Then, connect the charger to the dog training collar as it is shown on the photos
below. Lift the yellow rubber protective cover, and connect the charger. Now, switch on the dog
training collar. To switch it on, hold for 1 second the bottom part of the remote, where the built-in
magnet is (at the USB charging input), at the point where the indication light of the dog training
collar is. Then, remove the remote. In this way, the red indication light of the dog training collar is
constantly on, showing that the device is charging.
Advertisement
Table of Contents
Related Manuals for Servco DTR500
Summary of Contents for Servco DTR500
- Page 1 DOG TRAINING COLLAR WITH REMOTE MODELS: DTR500, 502, 503, 1500, 1502, 1503 CONTENTS The following items are included in the package, as shown on the photo below; dog training collar(s), USB charger(s), USB wire(s), USB adapter(s), long probes pair(s). PREPARING THE DOG TRAINING COLLAR WITH REMOTE FOR FIRST TIME USE The dog training collar needs to be charged for 5-6 hours.
- Page 2 After 5-6 hours of charging, remove the charger. Then, switch off the dog training collar, by holding the bottom part of the remote, for 4 seconds, where the built-in magnet is (at the USB charging input), at the point where the indication light of the dog training collar is. The remote needs to be charged for 4-5 hours.
- Page 3 PAIRING AND USE OF THE DOG TRAINING COLLAR WITH REMOTE The dog training collar(s) sent to you already paired with the remote. In case that you need to pair it again, do the following: The remote can control up to 3 dog training collars. The remote has 3 pairs of buttons (pair 1, pair 2, pair 3).
- Page 4 remote flashes to indicate the sending of the commands. The shock levels are adjusted by turning the rotary switch of the remote, from 1 until 8. Level 1 is the lowest level and level 8 is the highest level. After use, you can switch OFF the remote using the ON/OFF switch. TIPS &...
Need help?
Do you have a question about the DTR500 and is the answer not in the manual?
Questions and answers