Advertisement
•
For more information about scanning and filing airbag inflator recall claims, refer to Ordering and Managing
Replacement Inflators. From the iN, select Service, Warranty, then Claims Reference Guide. Under HOT
TIPS/TOPICS, select Ordering and Managing Replacement Inflators.
Replacing the front passenger's airbag inflator
Operation
Description
Number
Inspection only
7545A6
– no inflator
replacement.
Inspect and
7541C7
replace the
Takata inflator.
Skill Level:
Repair Technician
INSPECTION PROCEDURE
•
If the VIN status inquiry indicates that the vehicle is subject to any open safety recalls, including a driver's
airbag inflator campaign/recall, make sure to also complete those recall repairs before returning the vehicle
to the customer. If you are unable to complete any open recall, advise the customer of the recall status and
when the recall could be completed.
•
Make sure you have the anti-theft code for the audio and navigation system (if applicable), then write down the
frequencies for the audio unit's preset buttons.
•
Be careful not to damage any parts when replacing the inflator, and follow the procedure exactly.
•
If, before removing the airbag, you suspect that it may be the incorrect airbag for the vehicle or a counterfeit, do not
remove the airbag. Contact your DPSM for assistance.
•
Make sure you have reviewed the SRS Precautions and Procedures in the service repair information before doing
the REPAIR PROCEDURE.
1. Detach the glove box damper hook and remove the screws.
2. While holding the glove box, release the glove box stop on each side from the dashboard by pushing them in, then
remove the glovebox.
3. Disconnect the battery negative cable and wait at least 3 minutes before continuing.
Replacement
Flat
Part number
Rate
Time
No Inflator
0.3 hr
Replacement
04790-SDA-308
0.7 hr
04790-SDA-318
0.7 hr
Defect
Symptom
Code
Code
6CP00
KF000
6CP00
KF000
6CP00
KF000
Template ID
Failed Part Number
17-024A
06780-SDB-A80ZA
17-024B
06780-SDB-A80ZA
17-024C
06780-SDB-A80ZA
Page 3 of 18
Advertisement
