earth worth Grow Light Kit Assembly Instructions

PLEASE READ ALL WARNINGS PRIOR TO ASSEMBLY TO AVOID INJURY OR DAMAGE TO YOUR PRODUCT.
MAKE SURE ALL COMPONENTS ARE UNPLUGGED DURING ASSEMBLY.
• GROW LIGHTS ARE INTENDED FOR INDOOR USE ONLY.
• GROW LIGHTS ARE INTENDED FOR USE AS A HANGING LIGHT - IT SHOULD NOT BE ATTACHED TO ANY
SURFACE DIRECTLY.
• FOR SAFETY REASONS ALWAYS MAINTAIN 8-12" CLEARANCE ON ALL SIDES OF LIGHT.
• POWER CORD SHOULD RUN UP AND AWAY FROM THE TOP OF THE LIGHT.
• ANY HANGING MOUNTS SHOULD BE SECURELY ANCHORED DIRECTLY INTO CEILING STUDS, OR
HANGING FROM WEIGHT APPROPRIATE EXPANDING DRYWALL ANCHORS (50LB. LOAD PER ANCHOR).
• DO REMOVE ANY PROTECTIVE COVERINGS INSIDE THE GROW TUBE LIGHT BEFORE USE.
• DO TAKE PRECAUTIONS TO REMOVE FINGERPRINTS, DUST, OILS AND DEBRIS WITH GENTLE WINDOW
CLEANER FROM SURFACE OF LIGHT BULB BEFORE USE.
• NEVER USE A PUNCTURED OR CRACKED BULB - EVEN IF IT WORKS, SHUT OFF IMMEDIATELY, ONCE
COOLED, REPLACE BULB.
• NEVER LOOK DIRECTLY AT THE LIGHT WHEN IN USE TO PREVENT DAMAGE TO YOUR EYESIGHT.
• NEVER ATTEMPT TO REPLACE LIGHT BULBS, MOVE, CLEAN, SPRAY WHILE UNIT IS PLUGGED IN OR
WITHOUT GIVING COMPONENTS TIME TO COOL.
Grow Light Kit Tips:
• To avoid shattering or cracking lamp, do not allow lamp to ever contact water.
• If lamp breaks while in use, turn off system and allow bulb to cool completely before removing.
• For optimal performance, replace HPS lamps every 18 months and MH lamps every 12 months.
• If transferring your plants from a cooler lighting system, raise lights 12" higher than recommended
and increase exposure times gradually over a few days to prevent sunburning your plants.
• Light output may seem to wobble - this is to be expected with new bulbs and light should stabilize
after the first 100 hours of burn time.
• Lights take about 15-20 minutes to reach fullest intensity.
• Small glass debris inside the bulb is fairly common and does not affect performance.
• Do check for fissures or cracks in the bulb, even if light is working the bulb should be replaced
immediately.
Grow Light Kit
TM
Assembly Instructions
1000 Watt - 48"-72" from plants
600 Watt - 36"-48" from plants
400 Watt - 24"-36" from plants
www.earthworth.com
Copyright 2011 DTX International