Bintronic BT-073 Instruction Manual

Table of Contents
1-1 Setting or modifying position of Upper-Limit
1-2 Setting or modifying position of Lower-Limit
2-1 Adding another Remote Control Unit
3-1 Alter direction of Smart Roller Shades movement
4-1 Clear off Password
5-1 Externally connected Manual Switch Box
6-1 Battery Replacement
6-2 Product Specifications
6-3 Quick Setting Index
6-4 Instructions for using Remote Control Holder
Key check-points prior to
making settings
Press [SET] + [Open] keys until the Motor
STEP-1
makes a twitch, indicating the setting mode of
Upper-Limit is activated.
the Motor will make a twitch
back
Instruction Manual
OPEN
CLOSE
SET
When setting Upper-/Lower-Limit points,
set Upper-Limit first, then the Lower-Limit.
Press [Open] or [Close] key to move the Roller Shade to a
STEP-2
pre-determined position, to be set as the Upper-Limit.
When the Motor makes a
twitch, the Roller Shade
will move upwards and
downwards at the same
time as a response.
s
How to open Battery Compartment Cover
STOP
How to replace Battery Compartment Cover
Insert latches into
corresponding slots
MODE
Insert latches
First, make sure if the direction of movement is correct. Verify if the Roller Shade moves
upwards by pressing UP and downwards by pressing DOWN. After that, carry out setting or
modification of Upper-/Lower-Limit points. In case the Roller Shade moves in the
opposite direction, refer to the Steps of Item 3-1 in Table of Contents to correct the direction.
CAUTION
CAUTION
While the Shade is getting close to
While the Shade is getting close to
reaching the Upper-Limit, please press
reaching the Upper-Limit, please press
[Stop] to stop the movement to avoid
[Stop] to stop the movement to avoid
damage to the motor.Then, tap to fine
damage to the motor. Then, tap to fine
Tap to fine tune.
tune to the place where you would like
tune to the place where you would like
Press for 2 seconds,
it to be set up as the Upper-Limit.
it to be set up as the Upper-Limit.
Press for 2 seconds,
and it will move continuously.
Push the cover out
Place Battery
Compartment Cover
Push the cover in
to engage it with Slides
press [Stop]
and tap to fine tune
to the Upper-Limit
P.1