VelLight LEDC06 User Manual page 6

5. Press the effect buttons to generate different effects.
LEDC06 effects:
Button
FLASH
STROBE
FADE
SMOOTH
LEDC07 effects:
1. Press the effect buttons to generate different effects:
Auto, Flash, Jump3 (3 colours switching), Jump7
(7 colours switching), Fade3 (3 colours fading), Fade7
(7 colours fading).
2. To increase the speed of the effects, press Quick. To
decrease the speed, press Slow.
3. To pause the effect, press the
button again to restart.
LEDC07: Creating Custom Colours
You can define and store up to 6 custom colours using
the DIY1–6 buttons. When you press the DIY button,
the LED strip will change to your custom colour. For
example, to store a colour for button DIY1:
1. Press DIY1.
2. Use the coloured
own colour.
3. Press DIY1 again to store the colour. The LED strip
blinks once if the colour is stored correctly.
5. Battery
Refer to the illustration on page 3 of this manual.
The remote control uses 1 battery type 3 V lithium
CR2025 (included).
1. To (re)place the battery, press on the side of the
battery cover [6] and pull [7] to slide it open.
2. Insert the battery with the correct polarity and close
the battery compartment by pushing it back into the
housing of the remote control until it snaps into place.
Warning: Do not puncture batteries or throw
them in fire as they may explode. Do not
attempt to recharge non-rechargeable batteries
V. 02 – 21/10/2015
LEDC06/LEDC07
Effect
7 colours switching
gradual change
7 colours gradually changing
red, green, blue colours switching
and
button. Press the
buttons to mix your
6 ©Velleman nv