Page 1
T a b l e t - / B o o k H o l d e r Required Tools: Please note fine saw or scroll saw The Opitec Range of projects is not intended as play toys for sandpaper young children. They are teaching aids for young people pencil, ruler learning the skills of craft, design and technology.
Page 2
Instruction: 1. rill three ø 4 mm holes into two of four wooden strips (1a). Then counter-bore the two outer drilled holes by a depth of 4 mm. Take the remaining two wooden strips (1b) and mark the centre point of the face sides. In addition drill a ø...
Page 3
7. Glue the two wooden strips (2) to the face sides of the 8. Place a wooden wheel (5) between the wooden strip (2) wooden strip (3) as shown and fix each strip with a screw and the frame on both sides. Put a cylinder head screw (8) (7).
Page 4
14. The practical tablet or book holder is done. 13. Last glue the two sponge rubber cuts (a + b) to the bot- tom of the frame as shown and let it dry well. To adjust the angle, unscrew the wing nut and fasten the wing nut again.