Advertisement
Quick Links
Specifications
•Tweeter: 1" Swivel Silk Soft Dome ±3dB Tuning
•Woofer: 6.5" Kevlar Cone Rubber Surround
•Impedance: 8Ω
•Sensitivity: 86±3dB
•Frequency Range: 45Hz~20KHz
•Power Handling RMS: 100W
•Cut Out Diameter: 8.25"(210mm)
•Magnetic Grill Cover
•18 Degree Tilt Frame Design
5-YEAR LIMITED WARRANTY
Rave Technology products are warranted to be free from
defects in workmanship and materials for a period of Five
(5) years from the date of purchase without charge for
parts or labor. This warranty does not apply to units that
have been subject to misuse, abuse, neglect or improper
installation, and does not apply to repairs or alterations
made by unauthorized professional. This warranty
specifically excludes responsibility for consequential
damage. Retention of your original bill of sale is required
to obtain service under the terms of this warranty. © 2020
Rave Technology. All rights reserved. All trademarks are
the property of their respective owners. Specifications are
subject to change without notice.
Rave Technology
4100 East Baldwin Road Holly,
Michigan, 48442 USA
Tel: 866-303-2629
contact@ravetechnology.com
WWW.RAVETECHNOLOGY.COM
Ceiling Speaker
RKICT-650P
WWW.RAVETECHNOLOGY.COM
Advertisement
Summary of Contents for Rave Technology RKICT-650P
- Page 1 •Magnetic Grill Cover •18 Degree Tilt Frame Design 5-YEAR LIMITED WARRANTY Rave Technology products are warranted to be free from defects in workmanship and materials for a period of Five (5) years from the date of purchase without charge for parts or labor.
- Page 2 Distributed Audio Placement • Never overdrive your speakers to the point of distortion and always Rave Technology speakers possess extremely smooth and predictable off-axis reduce volume prior to switching input sources. frequency response. The chart below shows how far apart the speakers can be •...
- Page 3 Wire Gauge and Quality The total wire resistance should be less than 10% of the speaker impedance. Ifusing an 8 ohm speaker, your total wire resistance should be no more than 8 ohms. In simple terms, the extra resistance from the wire will have a very negativeeffect on the sound quality of the speaker.