Optex BGS-V2000 Series Instruction Manual

Photoelectric Sensor
BGS-V2000 SERIES
AC/DC Type
AC/DC Type
BGS-V2000 BGS-V2000T
DC Type
BGS-V2000
INSTRUCTION
MANUAL
¡ Confirm if the item meets your needs.
¡ Before the use, you should first thoroughly read
¡ this manual and operate correctly as mentioned.
¡ You should keep this manual at hand for proper use.
INPUT AND OUTPUT
DIAGRAMS
Optex-FA U.S. Sales
Ramco Innovations
(800) 280-6933
www.optex-ramco.com
SPECIFICATIONS
Detection distance
Detecting object
DC Type
Supply voltage
Current consumption
Response time
Hysteresis
Light Source
Sensitivity adjustment
Timer function
Indicator
Control output
Operation mode
Connection
Insulation Resistor
Withstand Voltage
Ambient temp./humidity
Ambient light
Protection category/Material
Weight
PART IDENTIFICATION
AC/DC type
Cable type BGS-V2000(T)
Connector type
12 ~ 24 VDC +/- 10%
24 ~ 240 VAC +/- 10% 50/60 Hz.
15% max. (@ 1m)
ON/OFF Delay 1 ~ 10 sec.
Output indicator: Orange LED, Stable incident indicator: Green LED
Relay output 1c 240 VAC 3A max.
Terminal base
2700 VAC 1 minute
Ambient light
*1 0.5m x 0.5m white paper
0.5 ~ 2m (*1)
Opaque object
5VA max.
20ms max.
IR LED
Teaching button
NPN/PNP Open collector
30 VDC 3A max.
Light ON Light ON / Dark ON
Terminal base / M12 connector
20 M ohm min. (500 VDC)
o
-25 ~ 55 C / 35 ~ 95% RH
Sunlight F10,000lx max. Incandescent lamp 3,000 lx max.
IP67 / Case: ABS, Lens: PC
110g
DC type
BGS-V2000(N,P)
BGS-V2000(CN,CP)
10 ~ 30 VDC +/- 10%
50mA max.
5ms max.
5% max. (@ 2m)
-----
30 VDC 100 mA max.
Select by switch
-----
95g