GlobaLux Lighting DCL2 Series Installation Instructions

Safety Precautions

1. Read all safety precautions and installation instructions carefully before installing or servicing this fixture.
Failure to comply with these instructions could result in potentially fatal electric shock and/or property
damage.
2. It is recommended that a qualified electrician perform all wiring. This fixture must be wired in accordance
with all national and local electrical codes.
3. Do not handle any energized fixture or attempt to energize any fixture with wet hands or while standing on
a wet or damp surface or in water.
4. This fixture is designed for use in a 120VAC, 60Hz fused circuit. This fixture is compatible with TRIAC
(forward-phase or leading-edge) and ELV (reverse-phase or trailing-edge) dimmers.
5. Make sure that the power source conforms to the requirements of the fixture. (See labels on the fixture
housing).
6. To reduce the risk of electrical shock, and to assure proper operation, this fixture must be adequately
grounded. To accomplish proper grounding, there must be a separate ground wire (green) contact between
this fixture and the ground connection of your main power supply panel.
7. This fixture is intended to be used for general indoor lighting in dry or damp locations.
8. Disclaimer
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and Canadian ICES-005 (B) /
NMB-005 (B). These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
1) Reorient or relocate the receiver antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4) Consult with the dealer or an experienced radio/TV technician for help.
Any modifications to this fixture may void the warranty and interfere with the safe operation of the luminaire.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device.
9. This fixture is suitable for ceiling and wall mounting.

NEEDED TOOLS

1. Tools and material needed: screwdriver, pliers, wire nuts, electrical tape.
2. To help prevent the possibility of electrical shock, the use of rubber sole shoes is recommended.
3. Exercise care when handling the fixture to avoid cuts or abrasions.
4. If a ladder is needed, make sure to use a sturdy wooden one.
Assembly Instructions
Step 1 – Preparing for installation
A. Disconnect electrical power before installing or servicing any part of this fixture.
：LED双环灯通用安装说明书
B. Remove fixture from carton; remove components from hardware kit.
：A4单面
GlobaLux Lighting LLC
编码：RIS0149
DCL2 Series
Installation Instructions
– 773 S. Benson Ave. Ontario, CA 91762 USA – 909-591-7506 Fax: 909-590-3220
www.globaluxlighting.com
1/2
RIS9916