Fig. 16: Removing Auxiliary Screw; Fig. 17: Compressor-End Foot - ABB HT600369 Operation Manual

Operation Manual / A170-M.. - A175-M..
3 Removal and installation / 3.3 Installing the turbocharger
Removing auxiliary screws
Fig. 16: Removing auxiliary screw
Remove shipping screws (90334 / 90335) on the left and right side of the foot and place
u
in the toolbox.
The turbocharger is delivered with a pre-installed sliding block (68003). The shipping screws
secure the sliding block in the preset position. In operation, the foot can slip due to thermal
expansion.
Tighten clamping nuts as described in the following sections.
u
Connect all gas, air and oil pipes.
u
If present: Re-fit the insulation segments.
u
If present: Connect cable to speed sensor.
u
Compressor-end (CE) foot
Fig. 17: Compressor-end foot
© Copyright 2020 ABB. All rights reserved. HZTL4033_EN Rev.G December 2020