Functions And Settings; Operation; Basic - Prolights Tribe JETSPOT-2 User Manual

Moving head
Table of Contents

Advertisement

Available languages

Available languages

- 3 - FUNCTIONS AND SETTINGS

3.1 OPERATION

Connect the supplied main cable to a socket (100-240V~/50-60Hz). The unit will run built-in program to
reset all motors to their home position. Shortly after that the JETSPOT-2 is ready for operation. To switch
off, disconnect the mains plug from the socket. For a more convenient operation it is recommended to
connect the unit to a socket which can be switched on and off via light switch.

3.2 BASIC

The control panel of JETSPOT-2 has a display and 5 buttons for the complete programming and manage-
ment of the projector menu (fig.4).
UP
Increases the value
displayed or passes to
the previous item in a
menu
Reversal of the display
To activate this function, hold simultaneously for 3 seconds UP and DOWN buttons while the display
is in the rest mode. This status will be memorised and maintained even for the next time it will be
switched on.
To return to the initial state, repeat the operation all over again.
JETSPOT- 2
DOWN
Decreases the value
displayed or passes to
the next item in the
menu
MENU
To enter in the main
menù or to return to the
top level
ENTER
Confirms the displayed
value, or activates the
displayed function, or
enters the successive
menu
Fig.4 - Functions of the buttons
7

Advertisement

Chapters

Table of Contents
loading

Table of Contents